Re: [PATCH] dt-bindings: net: xilinx_gmii2rgmii: Convert to json schema

[Krzysztof Kozlowski]

On 13/07/2023 12:34, Pranavi Somisetty wrote:
> Convert the Xilinx GMII to RGMII Converter device tree binding
> documentation to json schema.
> This converter is usually used as gem <---> gmii2rgmii <---> external phy
> and, it's phy-handle should point to the phandle of the external phy.
> 
> Signed-off-by: Pranavi Somisetty <pranavi.somisetty@xxxxxxx>

...

> +
> +description:
> +  The Gigabit Media Independent Interface (GMII) to Reduced Gigabit Media
> +  Independent Interface (RGMII) core provides the RGMII between RGMII-compliant
> +  ethernet physical media devices (PHY) and the Gigabit Ethernet controller.
> +  This core can be used in all three modes of operation(10/100/1000 Mb/s).
> +  The Management Data Input/Output (MDIO) interface is used to configure the
> +  speed of operation. This core can switch dynamically between the three
> +  different speed modes by configuring the converter register through mdio write.
> +  The core cannot function without an external phy connected to it.
> +
> +properties:
> +  compatible:
> +    const: xlnx,gmii-to-rgmii-1.0
> +
> +  reg:
> +    minimum: 0
> +    maximum: 31
> +    description: The ID number for the phy, usually a small integer.

Drop the "usually small...", it's obvious from constraints.

> +
> +  phy-handle: true

Where is this defined?

> +
> +required:
> +  - compatible
> +  - reg
> +  - phy-handle
> +
> +unevaluatedProperties: false

Either you miss $ref or this should be additionalProperties. I bet it's
the first problem.

> +
> +examples:
> +  - |
> +    mdio {
> +        #address-cells = <1>;
> +        #size-cells = <0>;
> +        phy: ethernet-phy@0 {
> +            reg = <0>;
> +        };

Drop this node, quite obvious.

> +        gmiitorgmii@8 {
> +            compatible = "xlnx,gmii-to-rgmii-1.0";
> +            reg = <8>;
> +            phy-handle = <&phy>;
> +        };
> +    };

Best regards,
Krzysztof