Re: [GIT PULL] bcachefs

[Jens Axboe]

On 6/27/23 4:05?PM, Dave Chinner wrote:
> On Tue, Jun 27, 2023 at 04:15:24PM -0400, Kent Overstreet wrote:
>> On Tue, Jun 27, 2023 at 11:16:01AM -0600, Jens Axboe wrote:
>>> On 6/26/23 8:59?PM, Jens Axboe wrote:
>>>> On 6/26/23 8:05?PM, Kent Overstreet wrote:
>>>>> On Mon, Jun 26, 2023 at 07:13:54PM -0600, Jens Axboe wrote:
>>>>>> Doesn't reproduce for me with XFS. The above ktest doesn't work for me
>>>>>> either:
>>>>>
>>>>> It just popped for me on xfs, but it took half an hour or so of looping
>>>>> vs. 30 seconds on bcachefs.
>>>>
>>>> OK, I'll try and leave it running overnight and see if I can get it to
>>>> trigger.
>>>
>>> I did manage to reproduce it, and also managed to get bcachefs to run
>>> the test. But I had to add:
>>>
>>> diff --git a/check b/check
>>> index 5f9f1a6bec88..6d74bd4933bd 100755
>>> --- a/check
>>> +++ b/check
>>> @@ -283,7 +283,7 @@ while [ $# -gt 0 ]; do
>>>  	case "$1" in
>>>  	-\? | -h | --help) usage ;;
>>>  
>>> -	-nfs|-afs|-glusterfs|-cifs|-9p|-fuse|-virtiofs|-pvfs2|-tmpfs|-ubifs)
>>> +	-nfs|-afs|-glusterfs|-cifs|-9p|-fuse|-virtiofs|-pvfs2|-tmpfs|-ubifs|-bcachefs)
>>>  		FSTYP="${1:1}"
>>>  		;;
>>>  	-overlay)
>>
>> I wonder if this is due to an upstream fstests change I haven't seen
>> yet, I'll have a look.
> 
> Run mkfs.bcachefs on the testdir first. fstests tries to probe the
> filesystem type to test if $FSTYP is not set. If it doesn't find a
> filesystem or it is unsupported, it will use the default (i.e. XFS).

I did format both test and scratch first with bcachefs, so guessing
something is going wrong with figuring out what filesystem is on the
device and then it defaults to XFS. I didn't spend too much time on that
bit, figured it was easier to just force bcachefs for my purpose.

> There should be no reason to need to specify the filesystem type for
> filesystems that blkid recognises. from common/config:
> 
>         # Autodetect fs type based on what's on $TEST_DEV unless it's been set
>         # externally
>         if [ -z "$FSTYP" ] && [ ! -z "$TEST_DEV" ]; then
>                 FSTYP=`blkid -c /dev/null -s TYPE -o value $TEST_DEV`
>         fi
>         FSTYP=${FSTYP:=xfs}
>         export FSTYP

Gotcha, yep it's because blkid fails to figure it out.

-- 
Jens Axboe