[PATCH 2/2] arm64: dts: qcom: sc8180x-flex-5g: remove superfluous "input-enable"

[Krzysztof Kozlowski]

Pin configuration property "input-enable" was used with the intention to
disable the output, but this is done by default by Linux drivers.  Since
commit c4a48b0df8bf ("dt-bindings: pinctrl: qcom: tlmm should use
output-disable, not input-enable") the property is not accepted anymore.

Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>
---
 arch/arm64/boot/dts/qcom/sc8180x-lenovo-flex-5g.dts | 3 ---
 1 file changed, 3 deletions(-)

diff --git a/arch/arm64/boot/dts/qcom/sc8180x-lenovo-flex-5g.dts b/arch/arm64/boot/dts/qcom/sc8180x-lenovo-flex-5g.dts
index fe3b366e1435..b12e0a61b3c0 100644
--- a/arch/arm64/boot/dts/qcom/sc8180x-lenovo-flex-5g.dts
+++ b/arch/arm64/boot/dts/qcom/sc8180x-lenovo-flex-5g.dts
@@ -497,7 +497,6 @@ hall_int_active_state: hall-int-active-state {
 		pins = "gpio121";
 		function = "gpio";
 
-		input-enable;
 		bias-disable;
 	};
 
@@ -513,7 +512,6 @@ i2c1_hid_active: i2c1-hid-active-state {
 		pins = "gpio122";
 		function = "gpio";
 
-		input-enable;
 		bias-pull-up;
 		drive-strength = <2>;
 	};
@@ -530,7 +528,6 @@ i2c7_hid_active: i2c7-hid-active-state {
 		pins = "gpio37", "gpio24";
 		function = "gpio";
 
-		input-enable;
 		bias-pull-up;
 		drive-strength = <2>;
 	};
-- 
2.34.1