Re: [PATCH v4 17/22] interconnect: qcom: icc-rpm: Control bus rpmcc from icc

[Stephan Gerhold]

On Tue, Jun 13, 2023 at 10:36:15PM +0200, Stephan Gerhold wrote:
> Not even compile tested this time!

Would have probably been worth it, sigh:

> 
> 	/*
> 	 * Downstream checks whether the requested rate is zero, but it makes little sense
> 	 * to vote for a value that's below the lower threshold, so let's not do so.
> 	 */
> 	if (qp->keep_alive)
> 		agg_clk_rate[QCOM_SMD_RPM_ACTIVE_STATE]
> 			= max(ICC_BUS_CLK_MIN_RATE, agg_clk_rate[QCOM_SMD_RPM_ACTIVE_STATE]);
> 
> 	/* Some providers have a non-RPM-owned bus clock - convert kHz->Hz for the CCF */
> 	if (qp->bus_clk) {
> 		rate = max_t(u64, agg_clk_rate[QCOM_SMD_RPM_ACTIVE_STATE],
> 			     agg_clk_rate[QCOM_SMD_RPM_SLEEP_STATE]);
> 		/* ARM32 caps clk_set_rate arg to u32.. Nothing we can do about that! */
> 		reate = min_t(u64, 1000ULL * rate, ULONG_MAX);
> 		return clk_set_rate(qp->bus_clk, rate);
> 	}
> 
> 	for (i = 0; i < QCOM_SMD_RPM_STATE_NUM; i++) {
> 		/* RPM only accepts <=INT_MAX rates */
> 		rate = min_t(u64, active_rate, INT_MAX);

->		rate = min_t(u64, agg_clk_rate[i], INT_MAX);

> 		if (rate == qp->bus_clk_rate[i])
> 			continue;
> 
> 		ret = qcom_icc_rpm_set_bus_rate(qp->bus_clk_desc, rate, i);
> 		if (ret)
> 			return ret;
> 
> 		/* Cache the rate after we've successfully commited it to RPM */
> 		qp->bus_clk_rate[i] = rate;
> 	}