Re: [PATCH RFC] soc: qcom: icc-bwmon: Set default thresholds dynamically

[Bjorn Andersson]

On Sat, Jun 10, 2023 at 02:01:53PM +0200, Konrad Dybcio wrote:
> Currently we use predefined threshold values. This works, but does not
> really scale well, as they may differ between SoCs due to LPDDR generation
> and/or DDR controller setup. All of the data we need for that is already
> provided in the device tree, anyway.
> 

Per your own argument, the replaced values are just initial values and
you should fairly quickly get some interrupt to start moving the
threshold up or down. I don't think your argumentation expresses
adequately why this "does not really scale well" and why your new values
happens to work better.

> Change that to:
> * 0 for low (as we've been doing up until now)
> * BW_MIN/4 for mid
> * BW_MIN for high
> 
> The mid value is chosen for a "low enough" bw to nudge bwmon into
> slowing down if the bw starts too high from the bootloader.
> 

As soon as we get the first interrupt, these values would be adjusted to
the bandwidth of the surrounding opp pair. So why is the /4 needed in
this initial state?

> The high value corresponds to the upper barrier which - when crossed -
> raises an interrupt in the third zone, signaling a need for upping
> the bw.
> 
> This only changes the values programmed at probe time, as high and med
> thresholds are updated at interrupt, based on the OPP table from DT.
> 

Your underlying reasoning, to remove the hard coded initial values,
sounds very reasonable to me.

Regards,
Bjorn

> Signed-off-by: Konrad Dybcio <konrad.dybcio@xxxxxxxxxx>
> ---
>  drivers/soc/qcom/icc-bwmon.c | 28 +++++++---------------------
>  1 file changed, 7 insertions(+), 21 deletions(-)
> 
> diff --git a/drivers/soc/qcom/icc-bwmon.c b/drivers/soc/qcom/icc-bwmon.c
> index 40068a285913..99cbdb3cf531 100644
> --- a/drivers/soc/qcom/icc-bwmon.c
> +++ b/drivers/soc/qcom/icc-bwmon.c
> @@ -165,9 +165,6 @@ enum bwmon_fields {
>  struct icc_bwmon_data {
>  	unsigned int sample_ms;
>  	unsigned int count_unit_kb; /* kbytes */
> -	unsigned int default_highbw_kbps;
> -	unsigned int default_medbw_kbps;
> -	unsigned int default_lowbw_kbps;
>  	u8 zone1_thres_count;
>  	u8 zone3_thres_count;
>  	unsigned int quirks;
> @@ -564,20 +561,21 @@ static void bwmon_set_threshold(struct icc_bwmon *bwmon,
>  static void bwmon_start(struct icc_bwmon *bwmon)
>  {
>  	const struct icc_bwmon_data *data = bwmon->data;
> +	u32 bw_low = 0;
>  	int window;
>  
> +	/* No need to check for errors, as this must have succeeded before. */
> +	dev_pm_opp_find_bw_ceil(bwmon->dev, &bw_low, 0);
> +
>  	bwmon_clear_counters(bwmon, true);
>  
>  	window = mult_frac(bwmon->data->sample_ms, HW_TIMER_HZ, MSEC_PER_SEC);
>  	/* Maximum sampling window: 0xffffff for v4 and 0xfffff for v5 */
>  	regmap_field_write(bwmon->regs[F_SAMPLE_WINDOW], window);
>  
> -	bwmon_set_threshold(bwmon, bwmon->regs[F_THRESHOLD_HIGH],
> -			    data->default_highbw_kbps);
> -	bwmon_set_threshold(bwmon, bwmon->regs[F_THRESHOLD_MED],
> -			    data->default_medbw_kbps);
> -	bwmon_set_threshold(bwmon, bwmon->regs[F_THRESHOLD_LOW],
> -			    data->default_lowbw_kbps);
> +	bwmon_set_threshold(bwmon, bwmon->regs[F_THRESHOLD_HIGH], bw_low);
> +	bwmon_set_threshold(bwmon, bwmon->regs[F_THRESHOLD_MED], div_u64(bw_low, 4));
> +	bwmon_set_threshold(bwmon, bwmon->regs[F_THRESHOLD_LOW], 0);
>  
>  	regmap_field_write(bwmon->regs[F_THRESHOLD_COUNT_ZONE0],
>  			   BWMON_THRESHOLD_COUNT_ZONE0_DEFAULT);
> @@ -807,9 +805,6 @@ static int bwmon_remove(struct platform_device *pdev)
>  static const struct icc_bwmon_data msm8998_bwmon_data = {
>  	.sample_ms = 4,
>  	.count_unit_kb = 1024,
> -	.default_highbw_kbps = 4800 * 1024, /* 4.8 GBps */
> -	.default_medbw_kbps = 512 * 1024, /* 512 MBps */
> -	.default_lowbw_kbps = 0,
>  	.zone1_thres_count = 16,
>  	.zone3_thres_count = 1,
>  	.quirks = BWMON_HAS_GLOBAL_IRQ,
> @@ -822,9 +817,6 @@ static const struct icc_bwmon_data msm8998_bwmon_data = {
>  static const struct icc_bwmon_data sdm845_cpu_bwmon_data = {
>  	.sample_ms = 4,
>  	.count_unit_kb = 64,
> -	.default_highbw_kbps = 4800 * 1024, /* 4.8 GBps */
> -	.default_medbw_kbps = 512 * 1024, /* 512 MBps */
> -	.default_lowbw_kbps = 0,
>  	.zone1_thres_count = 16,
>  	.zone3_thres_count = 1,
>  	.quirks = BWMON_HAS_GLOBAL_IRQ,
> @@ -835,9 +827,6 @@ static const struct icc_bwmon_data sdm845_cpu_bwmon_data = {
>  static const struct icc_bwmon_data sdm845_llcc_bwmon_data = {
>  	.sample_ms = 4,
>  	.count_unit_kb = 1024,
> -	.default_highbw_kbps = 800 * 1024, /* 800 MBps */
> -	.default_medbw_kbps = 256 * 1024, /* 256 MBps */
> -	.default_lowbw_kbps = 0,
>  	.zone1_thres_count = 16,
>  	.zone3_thres_count = 1,
>  	.regmap_fields = sdm845_llcc_bwmon_reg_fields,
> @@ -847,9 +836,6 @@ static const struct icc_bwmon_data sdm845_llcc_bwmon_data = {
>  static const struct icc_bwmon_data sc7280_llcc_bwmon_data = {
>  	.sample_ms = 4,
>  	.count_unit_kb = 64,
> -	.default_highbw_kbps = 800 * 1024, /* 800 MBps */
> -	.default_medbw_kbps = 256 * 1024, /* 256 MBps */
> -	.default_lowbw_kbps = 0,
>  	.zone1_thres_count = 16,
>  	.zone3_thres_count = 1,
>  	.quirks = BWMON_NEEDS_FORCE_CLEAR,
> 
> ---
> base-commit: 49dd846128d56199db2e3bcfca42d87fbc82b212
> change-id: 20230610-topic-bwmon_opp-f995bbdd18bd
> 
> Best regards,
> -- 
> Konrad Dybcio <konrad.dybcio@xxxxxxxxxx>
>