RE: [PATCH v2] PCI: rcar: use proper naming for R-Car

[Yoshihiro Shimoda]

Hello Wolfram-san,

> From: Wolfram Sang, Sent: Thursday, June 8, 2023 5:48 AM
> 
> Neither RCar, nor Rcar, but R-Car.
> 
> Signed-off-by: Wolfram Sang <wsa+renesas@xxxxxxxxxxxxxxxxxxxx>

Thank you for the patch!

Reviewed-by: Yoshihiro Shimoda <yoshihiro.shimoda.uh@xxxxxxxxxxx>

Best regards,
Yoshihiro Shimoda

> ---
> 
> Change since V1:
> * fix typo in $subject (Thanks, Biju!)
> 
>  drivers/pci/controller/pcie-rcar-host.c | 4 ++--
>  1 file changed, 2 insertions(+), 2 deletions(-)
> 
> diff --git a/drivers/pci/controller/pcie-rcar-host.c b/drivers/pci/controller/pcie-rcar-host.c
> index e80e56b2a842..f4dac8ff97cb 100644
> --- a/drivers/pci/controller/pcie-rcar-host.c
> +++ b/drivers/pci/controller/pcie-rcar-host.c
> @@ -684,7 +684,7 @@ static void rcar_compose_msi_msg(struct irq_data *data, struct msi_msg *msg)
>  }
> 
>  static struct irq_chip rcar_msi_bottom_chip = {
> -	.name			= "Rcar MSI",
> +	.name			= "R-Car MSI",
>  	.irq_ack		= rcar_msi_irq_ack,
>  	.irq_mask		= rcar_msi_irq_mask,
>  	.irq_unmask		= rcar_msi_irq_unmask,
> @@ -813,7 +813,7 @@ static int rcar_pcie_enable_msi(struct rcar_pcie_host *host)
> 
>  	/*
>  	 * Setup MSI data target using RC base address address, which
> -	 * is guaranteed to be in the low 32bit range on any RCar HW.
> +	 * is guaranteed to be in the low 32bit range on any R-Car HW.
>  	 */
>  	rcar_pci_write_reg(pcie, lower_32_bits(res.start) | MSIFE, PCIEMSIALR);
>  	rcar_pci_write_reg(pcie, upper_32_bits(res.start), PCIEMSIAUR);
> --
> 2.35.1