[PATCH v1 4/8] dt-bindings: can: m_can: add termination-{gpios,ohms} properties

[Leonard Göhrs]

The termination-gpios property allows specifying a GPIO pin that
enables/disables a termination resistor on said CAN interface.
The termination-ohms property specifies the resistance of said resistor.

Signed-off-by: Leonard Göhrs <l.goehrs@xxxxxxxxxxxxxx>
---
 Documentation/devicetree/bindings/net/can/bosch,m_can.yaml | 3 +++
 1 file changed, 3 insertions(+)

diff --git a/Documentation/devicetree/bindings/net/can/bosch,m_can.yaml b/Documentation/devicetree/bindings/net/can/bosch,m_can.yaml
index 67879aab623b5..106c79fa560c3 100644
--- a/Documentation/devicetree/bindings/net/can/bosch,m_can.yaml
+++ b/Documentation/devicetree/bindings/net/can/bosch,m_can.yaml
@@ -118,6 +118,9 @@ properties:
   phys:
     maxItems: 1
 
+  termination-gpios: true
+  termination-ohms: true
+
 required:
   - compatible
   - reg
-- 
2.39.2