Re: [PATCH v4 7/9] serial: sc16is7xx: fix regression with GPIO configuration

[Andy Shevchenko]

On Thu, Jun 1, 2023 at 2:57 AM Hugo Villeneuve <hugo@xxxxxxxxxxx> wrote:
> On Wed, 31 May 2023 00:56:57 +0300
> Andy Shevchenko <andy.shevchenko@xxxxxxxxx> wrote:
> > On Tue, May 30, 2023 at 6:36 PM Hugo Villeneuve <hugo@xxxxxxxxxxx> wrote:
> > > On Tue, 30 May 2023 01:38:17 +0300
> > > andy.shevchenko@xxxxxxxxx wrote:
> > > > Mon, May 29, 2023 at 10:07:09AM -0400, Hugo Villeneuve kirjoitti:

...

> > > > > +           of_property_for_each_u32(dev->of_node, "nxp,modem-control-line-ports",
> > > > > +                                    prop, p, u) {
> > > > > +                   if (u >= devtype->nr_uart)
> > > > > +                           continue;
> > > > > +
> > > > > +                   /* Use GPIO lines as modem control lines */
> > > > > +                   if (u == 0)
> > > > > +                           mctrl_mask |= SC16IS7XX_IOCONTROL_MODEM_A_BIT;
> > > > > +                   else if (u == 1)
> > > > > +                           mctrl_mask |= SC16IS7XX_IOCONTROL_MODEM_B_BIT;
> > > > > +           }
> > > >
> > > > Can we use device properties, please?
> > >
> > > I have converted this section to use device_property_count_u32() and device_property_read_u32_array(). Is that Ok?
> >
> > Yes, thank you!
>
> Hi Andy,
> now that I am using the device property API, I think I no longer have the need to test for "if (dev->of_node)" before reading the new property "nxp,modem-control-line-ports"?
>
> If that is the case, I will leave the test "if (dev->of_node)" only for the "irda-mode-ports" property.
>
> The pseudo code woulk look like this:
>
>         if (dev->of_node) {
>                 struct property *prop;
>                 const __be32 *p;
>                 u32 u;
>
>                 of_property_for_each_u32(dev->of_node, "irda-mode-ports",
>                                          prop, p, u)
>                         if (u < devtype->nr_uart)
>                                 s->p[u].irda_mode = true;
>         }
>
>         /* Read "nxp,modem-control-line-ports" using device property API. */
>         sc16is7xx_setup_mctrl_ports(dev);

Looks good to me, thank you for following the advice!

-- 
With Best Regards,
Andy Shevchenko