Re: [PATCH v5 1/3] rtc: tps6594: Add driver for TPS6594 RTC

[Alexandre Belloni]

On 23/05/2023 16:36:59+0300, andy.shevchenko@xxxxxxxxx wrote:
> Mon, May 22, 2023 at 06:31:13PM +0200, Esteban Blanc kirjoitti:
> > TPS6594 PMIC is a MFD. This patch adds support for
> > the RTC found inside TPS6594 family of PMIC.
> > 
> > Alarm is also supported.
> 
> ...
> 
> > +	help
> > +	  TI Power Management IC TPS6594 supports RTC functionality
> > +	  along with alarm. This driver supports the RTC driver for
> > +	  the TPS6594 RTC module.
> > +
> > +	  This driver can also be built as a module. If so, the module
> > +	  will be called tps6594-rtc
> 
> Grammar period at the end?
> 
> ...
> 
> > +#define TPS6594_GET_TIME_ON TPS6594_BIT_GET_TIME
> > +#define TPS6594_GET_TIME_OFF 0
> 
> Not used.
> 
> > +#define TPS6594_IT_ALARM_ON TPS6594_BIT_IT_ALARM
> > +#define TPS6594_IT_ALARM_OFF 0
> 
> Used only once.
> 
> > +#define TPS6594_AUTO_COMP_ON TPS6594_BIT_IT_ALARM
> 
> No _OFF counterpart.
> 
> That said the _OFF can be dropped completely. And the rest I see no value to
> have, just use those bit definitions directly?
> 
> ...
> 
> > +static int tps6594_rtc_alarm_irq_enable(struct device *dev,
> > +					unsigned int enabled)
> > +{
> > +	struct tps6594 *tps = dev_get_drvdata(dev->parent);
> > +	u8 val = 0;
> 
> Redundant assignment.
> 
> > +	val = enabled ? TPS6594_IT_ALARM_ON : TPS6594_IT_ALARM_OFF;
> > +
> > +	return regmap_update_bits(tps->regmap, TPS6594_REG_RTC_INTERRUPTS,
> > +				  TPS6594_BIT_IT_ALARM, val);
> > +}
> 
> ...
> 
> > +	// Read shadowed RTC registers.
> > +	ret = regmap_bulk_read(tps->regmap, TPS6594_REG_RTC_SECONDS, rtc_data,
> > +			       NUM_TIME_REGS);
> > +	if (ret < 0)
> > +		return ret;
> > +
> > +	tm->tm_sec = bcd2bin(rtc_data[0]);
> > +	tm->tm_min = bcd2bin(rtc_data[1]);
> > +	tm->tm_hour = bcd2bin(rtc_data[2]);
> > +	tm->tm_mday = bcd2bin(rtc_data[3]);
> > +	tm->tm_mon = bcd2bin(rtc_data[4]) - 1;
> > +	tm->tm_year = bcd2bin(rtc_data[5]) + 100;
> > +	tm->tm_wday = bcd2bin(rtc_data[6]);
> > +
> > +	return ret;
> 
> 	return 0;
> 
> No?
> 
> ...
> 
> > +static int tps6594_rtc_set_calibration(struct device *dev, int calibration)
> > +{
> > +	unsigned char comp_data[NUM_COMP_REGS];
> > +	struct tps6594 *tps = dev_get_drvdata(dev->parent);
> > +	__le16 value;
> > +	int ret;
> > +
> > +	/*
> > +	 * TPS6594 uses two's complement 16 bit value for compensation of RTC
> > +	 * crystal inaccuracies. One time every hour when seconds counter
> > +	 * increments from 0 to 1 compensation value will be added to internal
> > +	 * RTC counter value.
> > +	 *
> > +	 * Valid range for compensation value: [-32767 .. 32767].
> 
> This is defined naturally by the bits available, correct?
> 
> > +	 */
> > +	if (calibration < -32767 || calibration > 32767) {
> 
> So, this can be S16_MIN / S16_MAX range. The question here is what the
> -32768 meaning is and why it can't be used.
> 
> > +		dev_err(dev, "RTC calibration value out of range: %d\n",
> > +			calibration);
> > +		return -EINVAL;
> 
> -ERANGE
> 

And after using -ERANGE, you can drop the dev_err string.

> > +	}
> 
> > +	value = (__le16)calibration;
> > +
> > +	comp_data[0] = value & 0xFF;
> > +	comp_data[1] = (value >> 8) & 0xFF;
> 
> Of course these three lines is not what expected.
> 
> 	value = cpu_to_le16();
> 
> > +	// Update all the compensation registers in one shot.
> > +	ret = regmap_bulk_write(tps->regmap, TPS6594_REG_RTC_COMP_LSB,
> > +				comp_data, NUM_COMP_REGS);
> 
> 				&value, sizeof(value) ?
> 
> > +	if (ret < 0)
> > +		return ret;
> > +
> > +	// Enable automatic compensation.
> > +	return regmap_set_bits(tps->regmap, TPS6594_REG_RTC_CTRL_1,
> > +			       TPS6594_BIT_AUTO_COMP);
> > +}
> 
> ...
> 
> > +	ret = regmap_bulk_read(tps->regmap, TPS6594_REG_RTC_COMP_LSB, comp_data,
> > +			       NUM_COMP_REGS);
> > +	if (ret < 0)
> > +		return ret;
> > +
> > +	value = (__le16)comp_data[0] | ((__le16)comp_data[1] << 8);
> > +
> > +	*calibration = value;
> 
> In the similar (complementary API) way as above.
> 
> ...
> 
> > +	ret = devm_request_threaded_irq(&pdev->dev, irq, NULL,
> 
> Having
> 
> 	struct device *dev = &pdev->dev;
> 
> might make this and other lines shorter / neater.
> 
> > +					tps6594_rtc_interrupt, IRQF_ONESHOT,
> > +					TPS6594_IRQ_NAME_ALARM, &pdev->dev);
> > +	if (ret < 0)
> > +		return dev_err_probe(&pdev->dev, ret,
> > +				     "Failed to request_threaded_irq\n");
> 
> -- 
> With Best Regards,
> Andy Shevchenko
> 
> 

-- 
Alexandre Belloni, co-owner and COO, Bootlin
Embedded Linux and Kernel engineering
https://bootlin.com