Re: [PATCH 17/23] arm64: zynqmp: Switch to ethernet-phy-id in kv260

[Michal Simek]

On 5/2/23 15:35, Michal Simek wrote:
> Use ethernet-phy-id compatible string to properly describe phy reset on
> kv260 boards. Previous description wasn't correct because reset was done
> for mdio bus to operate and it was in this case used for different purpose
> which was eth phy reset. With ethernet-phy-id phy reset happens only for
> the phy via phy framework.
>
> Signed-off-by: Michal Simek <michal.simek@xxxxxxx>
> ---
>
>   arch/arm64/boot/dts/xilinx/zynqmp-sck-kv-g-revA.dtso | 6 ++++--
>   arch/arm64/boot/dts/xilinx/zynqmp-sck-kv-g-revB.dtso | 6 ++++--
>   2 files changed, 8 insertions(+), 4 deletions(-)
>
> diff --git a/arch/arm64/boot/dts/xilinx/zynqmp-sck-kv-g-revA.dtso b/arch/arm64/boot/dts/xilinx/zynqmp-sck-kv-g-revA.dtso
> index cb4a5126c4ec..817d756142ab 100644
> --- a/arch/arm64/boot/dts/xilinx/zynqmp-sck-kv-g-revA.dtso
> +++ b/arch/arm64/boot/dts/xilinx/zynqmp-sck-kv-g-revA.dtso
> @@ -146,16 +146,18 @@ &gem3 { /* required by spec */
>   	mdio: mdio {
>   		#address-cells = <1>;
>   		#size-cells = <0>;
> -		reset-gpios = <&gpio 38 GPIO_ACTIVE_LOW>;
> -		reset-delay-us = <2>;
>   
>   		phy0: ethernet-phy@1 {
>   			#phy-cells = <1>;
>   			reg = <1>;
> +			compatible = "ethernet-phy-id2000.a231";
>   			ti,rx-internal-delay = <DP83867_RGMIIDCTL_2_25_NS>;
>   			ti,tx-internal-delay = <DP83867_RGMIIDCTL_2_75_NS>;
>   			ti,fifo-depth = <DP83867_PHYCR_FIFO_DEPTH_4_B_NIB>;
>   			ti,dp83867-rxctrl-strap-quirk;
> +			reset-assert-us = <100>;
> +			reset-deassert-us = <280>;
> +			reset-gpios = <&gpio 38 GPIO_ACTIVE_LOW>;
>   		};
>   	};
>   };
> diff --git a/arch/arm64/boot/dts/xilinx/zynqmp-sck-kv-g-revB.dtso b/arch/arm64/boot/dts/xilinx/zynqmp-sck-kv-g-revB.dtso
> index 31bc120dee49..e07cec231ee0 100644
> --- a/arch/arm64/boot/dts/xilinx/zynqmp-sck-kv-g-revB.dtso
> +++ b/arch/arm64/boot/dts/xilinx/zynqmp-sck-kv-g-revB.dtso
> @@ -129,16 +129,18 @@ &gem3 { /* required by spec */
>   	mdio: mdio {
>   		#address-cells = <1>;
>   		#size-cells = <0>;
> -		reset-gpios = <&gpio 38 GPIO_ACTIVE_LOW>;
> -		reset-delay-us = <2>;
>   
>   		phy0: ethernet-phy@1 {
>   			#phy-cells = <1>;
>   			reg = <1>;
> +			compatible = "ethernet-phy-id2000.a231";
>   			ti,rx-internal-delay = <DP83867_RGMIIDCTL_2_25_NS>;
>   			ti,tx-internal-delay = <DP83867_RGMIIDCTL_2_75_NS>;
>   			ti,fifo-depth = <DP83867_PHYCR_FIFO_DEPTH_4_B_NIB>;
>   			ti,dp83867-rxctrl-strap-quirk;
> +			reset-assert-us = <100>;
> +			reset-deassert-us = <280>;
> +			reset-gpios = <&gpio 38 GPIO_ACTIVE_LOW>;
>   		};
>   	};
>   };


Applied.
M


--
Michal Simek, Ing. (M.Eng), OpenPGP -> KeyID: FE3D1F91
w: www.monstr.eu p: +42-0-721842854
Maintainer of Linux kernel - Xilinx Microblaze
Maintainer of Linux kernel - Xilinx Zynq ARM and ZynqMP/Versal ARM64 SoCs
U-Boot custodian - Xilinx Microblaze/Zynq/ZynqMP/Versal/Versal NET SoCs
TF-A maintainer - Xilinx ZynqMP/Versal/Versal NET SoCs