Re: [PATCH 04/23] arm64: zynqmp: Fix usb reset over bootmode pins on zcu100

[Michal Simek]

On 5/2/23 15:35, Michal Simek wrote:
> The commit 53ba1b2bdaf7 ("arm64: dts: zynqmp: Add mode-pin GPIO controller
> DT node") added usb phy reset over bootmode pins by default on usb0 only.
> zcu100 is using usb0 as peripheral and usb1 as host. Unfortunately reset
> line is shared for both usb ulpi phys but usb_rst_b is connected to usb5744
> hub which is used only in host mode. Especially this chip requires reset to
> operate properly that's why better assign gpio reset to usb1 instead of
> usb0.
>
> Signed-off-by: Michal Simek <michal.simek@xxxxxxx>
> ---
>
>   arch/arm64/boot/dts/xilinx/zynqmp-zcu100-revC.dts | 2 ++
>   1 file changed, 2 insertions(+)
>
> diff --git a/arch/arm64/boot/dts/xilinx/zynqmp-zcu100-revC.dts b/arch/arm64/boot/dts/xilinx/zynqmp-zcu100-revC.dts
> index 2dd552cf51fb..c99abb99efcb 100644
> --- a/arch/arm64/boot/dts/xilinx/zynqmp-zcu100-revC.dts
> +++ b/arch/arm64/boot/dts/xilinx/zynqmp-zcu100-revC.dts
> @@ -552,6 +552,7 @@ &usb0 {
>   	pinctrl-0 = <&pinctrl_usb0_default>;
>   	phy-names = "usb3-phy";
>   	phys = <&psgtr 2 PHY_TYPE_USB3 0 0>;
> +	/delete-property/ reset-gpios;
>   };
>   
>   &dwc3_0 {
> @@ -567,6 +568,7 @@ &usb1 {
>   	pinctrl-0 = <&pinctrl_usb1_default>;
>   	phy-names = "usb3-phy";
>   	phys = <&psgtr 3 PHY_TYPE_USB3 1 0>;
> +	reset-gpios = <&modepin_gpio 1 GPIO_ACTIVE_LOW>;
>   };
>   
>   &dwc3_1 {

Applied.
M

--
Michal Simek, Ing. (M.Eng), OpenPGP -> KeyID: FE3D1F91
w: www.monstr.eu p: +42-0-721842854
Maintainer of Linux kernel - Xilinx Microblaze
Maintainer of Linux kernel - Xilinx Zynq ARM and ZynqMP/Versal ARM64 SoCs
U-Boot custodian - Xilinx Microblaze/Zynq/ZynqMP/Versal/Versal NET SoCs
TF-A maintainer - Xilinx ZynqMP/Versal/Versal NET SoCs