[PATCH v2 4/4] arm64: dts: ti: k3-j721e-common-proc-board: Add OSPI/Hyperflash select pinmux

[Vaishnav Achath]

J721E common processor board has an onboard mux for selecting whether
the OSPI signals are externally routed to OSPI flash or Hyperflash. The
mux state signal input is tied to WKUP_GPIO0_8 and is used by bootloader
for enabling the corresponding node accordingly. Add pinmux for the same.

Signed-off-by: Vaishnav Achath <vaishnav.a@xxxxxx>
---
 arch/arm64/boot/dts/ti/k3-j721e-common-proc-board.dts | 11 +++++++++++
 1 file changed, 11 insertions(+)

diff --git a/arch/arm64/boot/dts/ti/k3-j721e-common-proc-board.dts b/arch/arm64/boot/dts/ti/k3-j721e-common-proc-board.dts
index c11c092c1ce0..185de41cb2f1 100644
--- a/arch/arm64/boot/dts/ti/k3-j721e-common-proc-board.dts
+++ b/arch/arm64/boot/dts/ti/k3-j721e-common-proc-board.dts
@@ -362,6 +362,12 @@
 			J721E_WKUP_IOPAD(0xb8, PIN_INPUT, 7) /* (F28) WKUP_GPIO0_2 */
 		>;
 	};
+
+	wkup_gpio_pins_default: wkup-gpio-pins-default {
+		pinctrl-single,pins = <
+			J721E_WKUP_IOPAD(0xd0, PIN_INPUT, 7) /* (C14) WKUP_GPIO0_8 */
+		>;
+	};
 };
 
 &wkup_uart0 {
@@ -419,6 +425,11 @@
 	status = "disabled";
 };
 
+&wkup_gpio0 {
+	pinctrl-names = "default";
+	pinctrl-0 = <&wkup_gpio_pins_default>;
+};
+
 &wkup_gpio1 {
 	status = "disabled";
 };
-- 
2.17.1