Re: [PATCH 2/2] ASoC: ssm3515: Add new amp driver

[Martin Povišer]

> On 10. 5. 2023, at 4:16, Mark Brown <broonie@xxxxxxxxxx> wrote:
> 
> On Tue, May 09, 2023 at 06:38:28PM +0200, Martin Povišer wrote:
> 
>> +static int ssm3515_setup(struct snd_soc_component *component)
>> +{
>> +	struct ssm3515_data *data =
>> +			snd_soc_component_get_drvdata(component);
>> +	int ret;
>> +
>> +	ret = snd_soc_component_update_bits(component, SSM3515_GEC,
>> +			SSM3515_GEC_ANA_GAIN,
>> +			FIELD_PREP(SSM3515_GEC_ANA_GAIN, data->ana_gain));
>> +	if (ret < 0)
>> +		return ret;
>> +
>> +	/* Start out muted */
>> +	ret = snd_soc_component_update_bits(component, SSM3515_DAC,
>> +			SSM3515_DAC_MUTE, SSM3515_DAC_MUTE);
>> +	if (ret < 0)
>> +		return ret;
> 
> Why are we not using the chip defaults here?  We use those for most
> things as what's appropraite for one user might not be appropriate for
> another and it's easier to agree to follow what the chip does than to
> select things.  There's some exceptions like for zero cross options but
> not typically for gains and mutes.

This bit is controlled by the mute DAI op, where it is expected the
component starts out muted. The datasheet promises pop-free experience
if this bit is sequenced with the disablement of clocks, so it seems
like a good fit for said op.

>> +static int ssm3515_probe(struct snd_soc_component *component)
>> +{
>> +	struct ssm3515_data *data =
>> +			snd_soc_component_get_drvdata(component);
>> +	int ret;
>> +
>> +	ret = ssm3515_reset(component);
>> +	if (ret < 0)
>> +		return ret;
>> +	regmap_reinit_cache(data->regmap, &ssm3515_i2c_regmap);
>> +
>> +	return ssm3515_setup(component);
>> +}
> 
> We don't normally reset things on component probe, only on bus level
> probe...

I don’t think I have a strong reason to do this.