Re: [PATCH v3 8/8] dt-bindings: Add rt5033 mfd, regulator and charger

[Rob Herring]

On Wed, May 03, 2023 at 09:33:49PM +0200, Jakob Hauser wrote:
> Hi Krzysztof, Hi all,
> 
> On 02.05.23 12:59, Krzysztof Kozlowski wrote:
> ...
> > Apologies for this, just very busy times. :)
> > 
> 
> Thanks for letting me know. Take the time you need.
> 
> Writing towards the list:
> 
> I think there is a misunderstanding here.
> 
> The connector node provides information about the installed USB hardware.
> E.g. property "usb-role-switch" means "Indicates that the device is capable
> of assigning the USB data role (USB host or USB device) for a given USB
> connector [...]" [5]. To my understanding, in relation with a port node this
> actually says that this port has this capability. This is not relevant to
> the rt5033-charger driver.
> 
> The rt5033-charger driver needs to pair with the extcon chip because it
> needs the information about *external* connectors being attached [6].
> 
> Extcon devices like SM5502 or SM5504 are real hardware. I'm not adding new
> properties. The way of getting an excton device from the devicetree by
> phandle is part of the extcon subsystem:
>  - function to get the excton device by phandle: [7]
>  - line that's looking for the property "extcon": [8]

extcon as a binding is inadequate for handling the increasing 
complexities of connectors. Whether we need another property to link 
things to connector nodes, perhaps.


> The connector node is the wrong approach, as far as I can tell on my current
> state of knowledge. It doesn't provide the information needed by the
> rt5033-charger driver.

What information is that?

You need information from the DT or run-time information from the 
'extcon chip driver'? In the latter case, I'd expect the charger driver 
to get its connector node (either TBD phandle or search the DT if 
there's only 1 possible connector), and from that get the driver 
controlling the connector.

Rob