[PATCH 3/3] thermal/drivers/mediatek/lvts_thermal: Disable undesired interrupts

[Nícolas F. R. A. Prado]

Out of the many interrupts supported by the hardware, the only ones of
interest to the driver currently are:
* The temperature went over the hot threshold, for any of the sensors
* The temperature went over the hot to normal threshold, for any of the
  sensors
* The temperature went over the stage3 threshold

These are the only thresholds configured by the driver through the
HTHRE, H2NTHRE, and PROTTC registers, respectively.

The current interrupt mask in LVTS_MONINT_CONF, enables many more
interrupts, including offset detection and data ready on sensors for
both filtered and immediate mode. These are not only not handled by the
driver, but they are also triggered too often, causing unneeded
overhead. Disable these unnecessary interrupts.

The meaning of each bit can be seen in the comment describing
LVTS_MONINTST in the IRQ handler.

Fixes: f5f633b18234 ("thermal/drivers/mediatek: Add the Low Voltage Thermal Sensor driver")
Signed-off-by: Nícolas F. R. A. Prado <nfraprado@xxxxxxxxxxxxx>
---

 drivers/thermal/mediatek/lvts_thermal.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/thermal/mediatek/lvts_thermal.c b/drivers/thermal/mediatek/lvts_thermal.c
index 29d10eaa8dfc..300ce22a7471 100644
--- a/drivers/thermal/mediatek/lvts_thermal.c
+++ b/drivers/thermal/mediatek/lvts_thermal.c
@@ -63,7 +63,7 @@
 #define LVTS_HW_FILTER				0x2
 #define LVTS_TSSEL_CONF				0x13121110
 #define LVTS_CALSCALE_CONF			0x300
-#define LVTS_MONINT_CONF			0x9FBF7BDE
+#define LVTS_MONINT_CONF			0x84804A52
 
 #define LVTS_INT_SENSOR0			0x0009001F
 #define LVTS_INT_SENSOR1			0x001203E0
-- 
2.40.0