Re: [PATCH v7 2/2] clk: wpcm450: Add Nuvoton WPCM450 clock/reset controller driver

[Philipp Zabel]

Hi Jonathan,

On Sun, Apr 23, 2023 at 12:02:40AM +0200, Jonathan Neuschäfer wrote:
> This driver implements the following features w.r.t. the clock and reset
> controller in the WPCM450 SoC:
> 
> - It calculates the rates for all clocks managed by the clock controller
> - It leaves the clock tree mostly unchanged, except that it enables/
>   disables clock gates based on usage.
> - It exposes the reset lines managed by the controller using the
>   Generic Reset Controller subsystem
> 
> NOTE: If the driver and the corresponding devicetree node are present,
>       the driver will disable "unused" clocks. This is problem until
>       the clock relations are properly declared in the devicetree (in a
>       later patch). Until then, the clk_ignore_unused kernel parameter
>       can be used as a workaround.
> 
> Signed-off-by: Jonathan Neuschäfer <j.neuschaefer@xxxxxxx>
[...]
> diff --git a/drivers/clk/clk-wpcm450.c b/drivers/clk/clk-wpcm450.c
> new file mode 100644
> index 0000000000000..6f6d8a1ea3484
> --- /dev/null
> +++ b/drivers/clk/clk-wpcm450.c
> @@ -0,0 +1,374 @@
[...]
> +static void __init wpcm450_clk_init(struct device_node *clk_np)
> +{
> +	struct clk_hw_onecell_data *clk_data;
> +	static struct clk_hw **hws;
> +	static struct clk_hw *hw;
> +	void __iomem *clk_base;
> +	int i, ret;
> +	struct reset_simple_data *reset;
[...]
> +	// Reset controller
> +	reset = kzalloc(sizeof(*reset), GFP_KERNEL);
> +	if (!reset)
> +		return;
> +	reset->rcdev.owner = THIS_MODULE;
> +	reset->rcdev.nr_resets = WPCM450_NUM_RESETS;
> +	reset->rcdev.ops = &reset_simple_ops;
> +	reset->rcdev.of_node = clk_np;
> +	reset->membase = clk_base + REG_IPSRST;
> +	ret = reset_controller_register(&reset->rcdev);
> +	if (ret)
> +		pr_err("Failed to register reset controller: %d\n", ret);

You could use %pe for consistency.

regards
Philipp