[RFC PATCH 2/2] net: phy: dp83869: fix mii mode when rgmii strap cfg is used

[Siddharth Vadapalli]

From: Grygorii Strashko <grygorii.strashko@xxxxxx>

The DP83869 PHY on TI's k3-am642-evm supports both MII and RGMII
interfaces and is configured by default to use RGMII interface (strap).
However, the board design allows switching dynamically to MII interface
for testing purposes by applying different set of pinmuxes.

To support switching to MII interface, update the DP83869 PHY driver to
configure OP_MODE_DECODE.RGMII_MII_SEL(bit 5) properly when MII PHY
interface mode is requested.

Signed-off-by: Grygorii Strashko <grygorii.strashko@xxxxxx>
Signed-off-by: Siddharth Vadapalli <s-vadapalli@xxxxxx>
---
 drivers/net/phy/dp83869.c | 5 ++++-
 1 file changed, 4 insertions(+), 1 deletion(-)

diff --git a/drivers/net/phy/dp83869.c b/drivers/net/phy/dp83869.c
index 9ab5eff502b7..8dbc502bcd9e 100644
--- a/drivers/net/phy/dp83869.c
+++ b/drivers/net/phy/dp83869.c
@@ -692,8 +692,11 @@ static int dp83869_configure_mode(struct phy_device *phydev,
 	/* Below init sequence for each operational mode is defined in
 	 * section 9.4.8 of the datasheet.
 	 */
+	phy_ctrl_val = dp83869->mode;
+	if (phydev->interface == PHY_INTERFACE_MODE_MII)
+		phy_ctrl_val |= DP83869_OP_MODE_MII;
 	ret = phy_write_mmd(phydev, DP83869_DEVADDR, DP83869_OP_MODE,
-			    dp83869->mode);
+			    phy_ctrl_val);
 	if (ret)
 		return ret;
 
-- 
2.25.1