Re: [PATCH v7 4/5] spi: dw: Add DMA address widths capability check

From: Joy Chakraborty
Date: Wed Apr 19 2023 - 17:03:55 EST


On Wed, Apr 19, 2023 at 11:05 PM Andy Shevchenko
<andriy.shevchenko@xxxxxxxxx> wrote:
>
> On Wed, Apr 19, 2023 at 06:18:04PM +0530, Joy Chakraborty wrote:
> > On Wed, Apr 19, 2023 at 5:19 PM Andy Shevchenko
> > <andriy.shevchenko@xxxxxxxxx> wrote:
> > > On Wed, Apr 19, 2023 at 11:18:25AM +0530, Joy Chakraborty wrote:
> > > > On Tue, Apr 18, 2023 at 1:08 PM Andy Shevchenko
> > > > <andriy.shevchenko@xxxxxxxxx> wrote:
> > > > > On Tue, Apr 18, 2023 at 05:29:01AM +0000, Joy Chakraborty wrote:
>
> ...
>
> > > > > > + /*
> > > > > > + * Assuming both channels belong to the same DMA controller hence the
> > > > > > + * address width capabilities most likely would be the same.
> > > > > > + */
> > > > >
> > > > > I had a small comment on this In v6 thread.
> > > >
> > > > Sure,
> > > >
> > > > Your comment in V6 thread:
> > > > "
> > > > I would add something to explain the side of these address width, like
> > > >
> > > > * Assuming both channels belong to the same DMA controller hence
> > > > * the peripheral side address width capabilities most likely would
> > > > * be the same.
> > > > "
> > > >
> > > > I do not think the address width capabilities are dependent on the
> > > > side of generation like memory or peripheral.
> > >
> > > Yes, they are independent. Memory could do with 4 bytes, while peripheral with
> > > 1 byte and so on.
> > >
> > > > From what I understand,
> > > > address width capabilities are solely dependent on the transaction
> > > > generation capability of the DMA controller towards the system bus.
> > >
> > > What do you mean by a SB in the above? Memory? Peripheral?
> >
> > By system bus I mean anything that is connecting the Memory, DMA and
> > the peripheral.
> > Something like :
> >
> > +-----------+ +-------------------+
> > | | | |
> > | DMA | | PERIPHERAL |
> > | | | |
> > +----^-+---+ +-----+--^---------+
> > *** -->| | | |
> > | | | |
> > <------------+-v--------------------v---+------------->
> > SYSTEM BUS
> > <---------------------+--^----------------------------->
> > | |
> > | |
> > +----v--+-----+
> > | |
> > | MEMORY |
> > | |
> > +--------------+
> > *** : Address width capabilities should be the capability of the DMA
> > to generate transactions to the system bus on the marked interface
> > irrespective of whether it is destined for Peripheral or memory is
> > what I understand.
>
> That's misunderstanding. You used only one possible HW design, there may be
> more. For example we have Synopsys DesignWare DMA that has a lot of parameters
> to configure bus mastering. One of such a case, where it makes a lot of sense,
> is DesignWare SATA with the above mentioned DMA controller where it has two
> masters and they are connected towards memory and towards peripheral "buses".
> They have _different_ configurations.
>
> So, generally speaking what you are saying is not true.

Got it, thank you for the clarification.
I misunderstood what you meant, that peripheral access can be from a
different path.

I shall add to the comment as you suggested and send another patch.

>
> > > > What we intend to highlight here is the assumption that both tx and rx
> > > > channel would belong to the same DMA controller hence the transaction
> > > > generation capabilities would be the same both for read and write
> > > > (e.g. if the DMA controller is able to generate 32 bit sized reads
> > > > then it should also be able to generate 32 bit sized writes).
> > > > With this assumption we are doing a bitwise and of both tx and rx capabilities.
> > > >
> > > > Please let me know if you think otherwise.
>
> --
> With Best Regards,
> Andy Shevchenko
>
>