Re: [PATCH v7 4/5] spi: dw: Add DMA address widths capability check

From: Joy Chakraborty
Date: Wed Apr 19 2023 - 10:56:21 EST


On Wed, Apr 19, 2023 at 6:18 PM Joy Chakraborty <joychakr@xxxxxxxxxx> wrote:
>
> On Wed, Apr 19, 2023 at 5:19 PM Andy Shevchenko
> <andriy.shevchenko@xxxxxxxxx> wrote:
> >
> > On Wed, Apr 19, 2023 at 11:18:25AM +0530, Joy Chakraborty wrote:
> > > On Tue, Apr 18, 2023 at 1:08 PM Andy Shevchenko
> > > <andriy.shevchenko@xxxxxxxxx> wrote:
> > > > On Tue, Apr 18, 2023 at 05:29:01AM +0000, Joy Chakraborty wrote:
> >
> > ...
> >
> > > > > + /*
> > > > > + * Assuming both channels belong to the same DMA controller hence the
> > > > > + * address width capabilities most likely would be the same.
> > > > > + */
> > > >
> > > > I had a small comment on this In v6 thread.
> > >
> > > Sure,
> > >
> > > Your comment in V6 thread:
> > > "
> > > I would add something to explain the side of these address width, like
> > >
> > > * Assuming both channels belong to the same DMA controller hence
> > > * the peripheral side address width capabilities most likely would
> > > * be the same.
> > > "
> > >
> > > I do not think the address width capabilities are dependent on the
> > > side of generation like memory or peripheral.
> >
> > Yes, they are independent. Memory could do with 4 bytes, while peripheral with
> > 1 byte and so on.
> >
> > > From what I understand,
> > > address width capabilities are solely dependent on the transaction
> > > generation capability of the DMA controller towards the system bus.
> >
> > What do you mean by a SB in the above? Memory? Peripheral?
>
> By system bus I mean anything that is connecting the Memory, DMA and
> the peripheral.
> Something like :
>
> +-----------+ +-------------------+
> | | | |
> | DMA | | PERIPHERAL |
> | | | |
> +----^-+---+ +-----+--^---------+
> *** -->| | | |
> | | | |
> <------------+-v--------------------v---+------------->
> SYSTEM BUS
> <---------------------+--^----------------------------->
> | |
> | |
> +----v--+-----+
> | |
> | MEMORY |
> | |
> +--------------+
> *** : Address width capabilities should be the capability of the DMA
> to generate transactions to the system bus on the marked interface
> irrespective of whether it is destined for Peripheral or memory is
> what I understand.
>
Looks like the diagram did not come correctly, repasting:
+----------+ +---------------+
| | | |
| DMA | | PERIPHERAL |
| | | |
+----^-+---+ +-----+--^------+
***-->| | | |
| | | |
| | | |
<------------+-v--------------------v--+--------------->
SYSTEM BUS
<---------------------+--^----------------------------->
| |
| |
| |
+----v--+-----+
| MEMORY |
| |
+-------------+

> >
> > > What we intend to highlight here is the assumption that both tx and rx
> > > channel would belong to the same DMA controller hence the transaction
> > > generation capabilities would be the same both for read and write
> > > (e.g. if the DMA controller is able to generate 32 bit sized reads
> > > then it should also be able to generate 32 bit sized writes).
> > > With this assumption we are doing a bitwise and of both tx and rx capabilities.
> > >
> > > Please let me know if you think otherwise.
> >
> > --
> > With Best Regards,
> > Andy Shevchenko
> >
> >