Re: [Patch v6 6/9] cpufreq: tegra194: add OPP support and set bandwidth

From: Sumit Gupta
Date: Tue Apr 18 2023 - 06:23:39 EST




On 18/04/23 14:43, Viresh Kumar wrote:
External email: Use caution opening links or attachments


On 11-04-23, 16:29, Sumit Gupta wrote:
Add support to use OPP table from DT in Tegra194 cpufreq driver.
Tegra SoC's receive the frequency lookup table (LUT) from BPMP-FW.
Cross check the OPP's present in DT against the LUT from BPMP-FW
and enable only those DT OPP's which are present in LUT also.

The OPP table in DT has CPU Frequency to bandwidth mapping where
the bandwidth value is per MC channel. DRAM bandwidth depends on the
number of MC channels which can vary as per the boot configuration.
This per channel bandwidth from OPP table will be later converted by
MC driver to final bandwidth value by multiplying with number of
channels before sending the request to BPMP-FW.

If OPP table is not present in DT, then use the LUT from BPMP-FW
directy as the CPU frequency table and not do the DRAM frequency
scaling which is same as the current behavior.

Now, as the CPU Frequency table is being controlling through OPP
table in DT. Keeping fewer entries in the table will create less
frequency steps and can help to scale fast to high frequencies
when required.

Signed-off-by: Sumit Gupta <sumitg@xxxxxxxxxx>
---
drivers/cpufreq/tegra194-cpufreq.c | 156 ++++++++++++++++++++++++++---
1 file changed, 143 insertions(+), 13 deletions(-)

Can this be applied independently of the rest of the series ?

--
viresh

Yes, this can be applied independently.

Thank you,
Sumit Gupta