Re: [PATCH v3 0/3] spi: Add DMA mode support to spi-qcom-qspi

From: Vijaya Krishna Nivarthi
Date: Fri Apr 14 2023 - 13:01:41 EST


On 4/14/2023 10:12 PM, Doug Anderson wrote:
Hi,

On Fri, Apr 14, 2023 at 8:48 AM Doug Anderson <dianders@xxxxxxxxxxxx> wrote:
Hi,

On Fri, Apr 14, 2023 at 7:06 AM Vijaya Krishna Nivarthi
<quic_vnivarth@xxxxxxxxxxx> wrote:
There are large number of QSPI irqs that fire during boot/init and later
on every suspend/resume.
This could be made faster by doing DMA instead of PIO.
Below is comparison for number of interrupts raised in 2 acenarios...
s/acenarios/scenarios

Boot up and stabilise
Suspend/Resume

Sequence PIO DMA
=======================
Boot-up 69088 19284
S/R 5066 3430

Though we have not made measurements for speed, power we expect
the performance to be better with DMA mode and no regressions were
encountered in testing.
Measuring the speed isn't really very hard, so I gave it a shot.

I used a truly terrible python script to do this on a Chromebook:

--

import os
import time

os.system("""
stop ui
stop powerd

cd /sys/devices/system/cpu/cpufreq
for policy in policy*; do
cat ${policy}/cpuinfo_max_freq > ${policy}/scaling_min_freq
done
""")

all_times = []
for i in range(1000):
start = time.time()
os.system("flashrom -p host -r /tmp/foo.bin")
end = time.time()

all_times.append(end - start)
print("Iteration %d, min=%.2f, max=%.2f, avg=%.2f" % (
i, min(all_times), max(all_times), sum(all_times) / len(all_times)))

--

The good news is that after applying your patches the loop runs _much_ faster.

The bad news is that it runs much faster because it very quickly fails
and errors out. flashrom just keeps reporting:

Opened /dev/mtd0 successfully
Found Programmer flash chip "Opaque flash chip" (8192 kB,
Programmer-specific) on host.
Reading flash... Cannot read 0x001000 bytes at 0x000000: Connection timed out
read_flash: failed to read (00000000..0x7fffff).
Read operation failed!
FAILED.
FAILED

I went back and tried v1, v2, and v3 and all three versions fail.
Ah, I see what's likely the problem. Your patch series only adds the
"iommus" for sc7280 but I'm testing on sc7180. That means:

1. You need to add the iommus to _all_ the boards that have qspi. That
means sc7280, sc7180, and sdm845.

2. Ideally the code should still be made to work (it should fall back
to PIO mode) if DMA isn't properly enabled. That would keep old device
trees working, which we're supposed to do.


Thank you very much for the review, script, test and quick debug.
Will check same and update a v4.

-Vijay/


-Doug