Re: [PATCH] drm/msm/dpu: always program dsc active bits

[Abhinav Kumar]

On 4/14/2023 12:35 AM, Marijn Suijten wrote:
> On 2023-04-12 10:33:15, Abhinav Kumar wrote:
> [..]
> > > What happens if a device boots without DSC panel connected?  Will
> > > CTL_DSC_FLUSH be zero and not (unnecessarily, I assume) flush any of the
> > > DSC blocks?  Or could this flush uninitialized state to the block?
> >
> > If we bootup without DSC panel connected, the kernel's cfg->dsc will be
> > 0 and default register value of CTL_DSC_FLUSH will be 0 so it wont flush
> > any DSC blocks.
>
> Ack, that makes sense.  However, if I connect a DSC panel, then
> disconnect it (now the register should be non-zero, but cfg->dsc will be
> zero), and then replug a non-DSC panel multiple times, it'll get flushed
> every time because we never clear CTL_DSC_FLUSH after that?

If we remove it after kernel starts, that issue is there even today 
without that change because DSI is not a hot-pluggable display so a 
teardown wont happen when you plug out the panel. How will cfg->dsc be 0 
then? In that case, its not a valid test as there was no indication to 
DRM that display was disconnected so we cannot tear it down.

> > Sure, as I wrote in the other response, we can move this
> > to reset_intf_cfg later when the other pieces are fixed. And leave a
> > FIXME here.
>
> Kuogee forgot to CC me on this patchs so I did not read/receive that
> side of the email thread.  Will catch up before reviewing v2.
>
> - Marijn