Re: Aw: Re: [PATCH] dt-bindings: mt76: add active-low property to led

[Krzysztof Kozlowski]

On 07/02/2023 13:12, Frank Wunderlich wrote:
>> Gesendet: Dienstag, 07. Februar 2023 um 11:40 Uhr
>> Von: "Krzysztof Kozlowski" <krzysztof.kozlowski@xxxxxxxxxx>
>> On 07/02/2023 11:25, Frank Wunderlich wrote:
>>> From: Frank Wunderlich <frank-w@xxxxxxxxxxxxxxx>
>>>
>>> LEDs can be in low-active mode, so add dt property for it.
>>>
>>> Signed-off-by: Frank Wunderlich <frank-w@xxxxxxxxxxxxxxx>
>>> ---
>>>  .../devicetree/bindings/net/wireless/mediatek,mt76.yaml      | 5 +++++
>>>  1 file changed, 5 insertions(+)
>>>
>>> diff --git a/Documentation/devicetree/bindings/net/wireless/mediatek,mt76.yaml b/Documentation/devicetree/bindings/net/wireless/mediatek,mt76.yaml
>>> index f0c78f994491..212508672979 100644
>>> --- a/Documentation/devicetree/bindings/net/wireless/mediatek,mt76.yaml
>>> +++ b/Documentation/devicetree/bindings/net/wireless/mediatek,mt76.yaml
>>> @@ -112,6 +112,11 @@ properties:
>>>      $ref: /schemas/leds/common.yaml#
>>>      additionalProperties: false
>>>      properties:
>>> +      led-active-low:
>>> +        description:
>>> +          LED is enabled with ground signal.
>>
>> What does it mean? You set voltage of regulator to 0? Or you set GPIO as
>> 0? If the latter, it's not the property of LED...
> 
> basicly it is a gpio-led mapped into the mt76 driver, but not passing gpio itself in this property (like gpio-led does).
> This gpio is set to 0 signal (gnd) to let the led go on ;) so imho it is a led-property, but below the wifi-node as
> the trigger comes from mt76 hardware, not an external (soc) gpio controller.
> 
> mt76 driver supports it already like i post change here:
> 

If the driver supports it already and it was never documented, please
state it. Your commit says you add a new property.

Best regards,
Krzysztof