[PATCH v7 5/5] clk: qcom: lpassaudiocc-sc7280: Skip lpass_aon_cc_pll config

[Srinivasa Rao Mandadapu]

Skip lpass_aon_cc_pll configuration for ADSP based platforms
based on qcom,adsp-pil-mode property.
This is to avoid ADSP out of reset fail.

Signed-off-by: Srinivasa Rao Mandadapu <quic_srivasam@xxxxxxxxxxx>
Tested-by: Mohammad Rafi Shaik <quic_mohs@xxxxxxxxxxx>
---
 drivers/clk/qcom/lpassaudiocc-sc7280.c | 8 +++++++-
 1 file changed, 7 insertions(+), 1 deletion(-)

diff --git a/drivers/clk/qcom/lpassaudiocc-sc7280.c b/drivers/clk/qcom/lpassaudiocc-sc7280.c
index 8e2f433..76611a3 100644
--- a/drivers/clk/qcom/lpassaudiocc-sc7280.c
+++ b/drivers/clk/qcom/lpassaudiocc-sc7280.c
@@ -847,7 +847,13 @@ static int lpass_aon_cc_sc7280_probe(struct platform_device *pdev)
 		goto exit;
 	}
 
-	clk_lucid_pll_configure(&lpass_aon_cc_pll, regmap, &lpass_aon_cc_pll_config);
+	/*
+	 * ADSP firmware is in control of this PLL frequency when
+	 * remoteproc is used. Skip frequency configuration in that
+	 * case.
+	 */
+	if (!of_property_read_bool(pdev->dev.of_node, "qcom,adsp-pil-mode"))
+		clk_lucid_pll_configure(&lpass_aon_cc_pll, regmap, &lpass_aon_cc_pll_config);
 
 	ret = qcom_cc_really_probe(pdev, &lpass_aon_cc_sc7280_desc, regmap);
 	if (ret) {
-- 
2.7.4