[PATCH v2 2/2] irqchip: Kconfig: Added module build support for the TI interrupt aggregator

[Nicolas Frayer]

Added module build support in Kconfig for the TI SCI interrupt aggregator
driver. The driver's default build is built-in and it also depends on
ARCH_K3 as the driver uses some 64 bit ops and should only be built
for 64 bit platforms.

Signed-off-by: Nicolas Frayer <nfrayer@xxxxxxxxxxxx>
---
 arch/arm64/Kconfig.platforms | 1 -
 drivers/irqchip/Kconfig      | 5 +++--
 2 files changed, 3 insertions(+), 3 deletions(-)

diff --git a/arch/arm64/Kconfig.platforms b/arch/arm64/Kconfig.platforms
index 6ede8e105af52..26cd5021d265c 100644
--- a/arch/arm64/Kconfig.platforms
+++ b/arch/arm64/Kconfig.platforms
@@ -128,7 +128,6 @@ config ARCH_K3
 	select SOC_TI
 	select TI_MESSAGE_MANAGER
 	select TI_SCI_PROTOCOL
-	select TI_SCI_INTA_IRQCHIP
 	select TI_K3_SOCINFO
 	help
 	  This enables support for Texas Instruments' K3 multicore SoC
diff --git a/drivers/irqchip/Kconfig b/drivers/irqchip/Kconfig
index e773357e4ab03..77be35559168e 100644
--- a/drivers/irqchip/Kconfig
+++ b/drivers/irqchip/Kconfig
@@ -517,10 +517,11 @@ config TI_SCI_INTR_IRQCHIP
 	  TI System Controller, say Y here. Otherwise, say N.
 
 config TI_SCI_INTA_IRQCHIP
-	bool
-	depends on TI_SCI_PROTOCOL
+	tristate "TI SCI INTA Interrupt Controller"
+	depends on ARCH_K3 && TI_SCI_PROTOCOL
 	select IRQ_DOMAIN_HIERARCHY
 	select TI_SCI_INTA_MSI_DOMAIN
+	default ARCH_K3
 	help
 	  This enables the irqchip driver support for K3 Interrupt aggregator
 	  over TI System Control Interface available on some new TI's SoCs.
-- 
2.25.1