Re: [PATCH v7 0/6] clk/qcom: Support gdsc collapse polling using 'reset' interface

From: Bjorn Andersson
Date: Wed Dec 07 2022 - 11:55:14 EST


On Wed, Dec 07, 2022 at 05:00:51PM +0100, Ulf Hansson wrote:
> On Thu, 1 Dec 2022 at 23:57, Bjorn Andersson <andersson@xxxxxxxxxx> wrote:
> >
> > On Wed, Oct 05, 2022 at 02:36:58PM +0530, Akhil P Oommen wrote:
> > >
> >
> > @Ulf, Akhil has a power-domain for a piece of hardware which may be
> > voted active by multiple different subsystems (co-processors/execution
> > contexts) in the system.
> >
> > As such, during the powering down sequence we don't wait for the
> > power-domain to turn off. But in the event of an error, the recovery
> > mechanism relies on waiting for the hardware to settle in a powered off
> > state.
> >
> > The proposal here is to use the reset framework to wait for this state
> > to be reached, before continuing with the recovery mechanism in the
> > client driver.
>
> I tried to review the series (see my other replies), but I am not sure
> I fully understand the consumer part.
>
> More exactly, when and who is going to pull the reset and at what point?
>
> >
> > Given our other discussions on quirky behavior, do you have any
> > input/suggestions on this?
> >
> > > Some clients like adreno gpu driver would like to ensure that its gdsc
> > > is collapsed at hardware during a gpu reset sequence. This is because it
> > > has a votable gdsc which could be ON due to a vote from another subsystem
> > > like tz, hyp etc or due to an internal hardware signal. To allow
> > > this, gpucc driver can expose an interface to the client driver using
> > > reset framework. Using this the client driver can trigger a polling within
> > > the gdsc driver.
> >
> > @Akhil, this description is fairly generic. As we've reached the state
> > where the hardware has settled and we return to the client, what
> > prevents it from being powered up again?
> >
> > Or is it simply a question of it hitting the powered-off state, not
> > necessarily staying there?
>
> Okay, so it's indeed the GPU driver that is going to assert/de-assert
> the reset at some point. Right?
>
> That seems like a reasonable approach to me, even if it's a bit
> unclear under what conditions that could happen.
>

Generally the disable-path of the power-domain does not check that the
power-domain is actually turned off, because the status might indicate
that the hardware is voting for the power-domain to be on.

As part of the recovery of the GPU after some fatal fault, the GPU
driver does something which will cause the hardware votes for the
power-domain to be let go, and then the driver does pm_runtime_put().

But in this case the GPU driver wants to ensure that the power-domain is
actually powered down, before it does pm_runtime_get() again. To ensure
that the hardware lost its state...

The proposal here is to use a reset to reach into the power-domain
provider and wait for the hardware to be turned off, before the GPU
driver attempts turning the power-domain on again.


In other words, there is no reset. This is a hack to make a normally
asynchronous pd.power_off() to be synchronous in this particular case.

Regards,
Bjorn