[PATCH 3/3] spi: dw: Write chip configuration before cs is set

[Edmund Berenson]

Using chips with different cpol, causes first communication
to fail on cpol change.
To avoid this issue write cr0 register before cs is set.

Suggested-by: Lukasz Zemla <Lukasz.Zemla@xxxxxxxxxxxx>
Signed-off-by: Edmund Berenson <edmund.berenson@xxxxxxxxx>
---
 drivers/spi/spi-dw-core.c | 8 +++++++-
 1 file changed, 7 insertions(+), 1 deletion(-)

diff --git a/drivers/spi/spi-dw-core.c b/drivers/spi/spi-dw-core.c
index 57c9e384d6d4..c3da4fe3e510 100644
--- a/drivers/spi/spi-dw-core.c
+++ b/drivers/spi/spi-dw-core.c
@@ -93,6 +93,7 @@ static inline void dw_spi_debugfs_remove(struct dw_spi *dws)
 void dw_spi_set_cs(struct spi_device *spi, bool enable)
 {
 	struct dw_spi *dws = spi_controller_get_devdata(spi->controller);
+	struct dw_spi_chip_data *chip = spi_get_ctldata(spi);
 	bool cs_high = !!(spi->mode & SPI_CS_HIGH);
 	u8 enable_cs = 0;
 
@@ -106,8 +107,13 @@ void dw_spi_set_cs(struct spi_device *spi, bool enable)
 	 * Enable register no matter whether the SPI core is configured to
 	 * support active-high or active-low CS level.
 	 */
-	if (cs_high == enable)
+	if (cs_high == enable) {
+		dw_spi_enable_chip(dws, 0);
+		dw_writel(dws, DW_SPI_CTRLR0, chip->cr0);
+		dw_spi_enable_chip(dws, 1);
+
 		dw_writel(dws, DW_SPI_SER, BIT(enable_cs));
+	}
 	else
 		dw_writel(dws, DW_SPI_SER, 0);
 }
-- 
2.37.4