RE: [PATCH 1/2] perf/arm-cmn: Cope with spurious IRQs better

From: Geoff Blake
Date: Wed Nov 30 2022 - 18:21:23 EST



> > From my perspective, this is a worse solution as now we're sweeping an
> > issue under the rug and consuming CPU cycles handling IRQs we should not
> > be getting in the first place. While an overflow IRQ from the cmn should
> > not be high frequency, there is a non-zero chance in the future it could
> > be and this could lead to a very hard to debug performance issue instead
> > of the current problem, which is discovering we need to clean up better
> > from a noisy kernel message.
>
> Kexec is not the only possible source of spurious IRQs. If they cause a
> problem for this driver, that cannot be robustly addressed by trying to
> rely on whatever software might happen to run before this driver.

Sure, I can agree with the assertion a spurious IRQ could come from
anywhere, in that case though, shouldn't the behavior still be to log
spurious IRQs as a warning instead of silently sinking them?

> > The driver as best I can grok currently is optimized to limit the amount
> > of register writes for the common use-case, which is setting and unsetting
> > events, so all the wiring for the PMU to feed events to the DTC is done up
> > front on load: DTC_CTL's DT_EN bit is set immediately during probe, as is
> > OVFL_INTR_EN. All the DN states and DTM PMU_CONFIG_PMU_EN is deferred
> > for when an event is actually set, and here we go through all of them
> > anyways for each event unless its bynodeid, so the expense of setting
> > events grows linearly with the mesh size anyways.
>
> If arm_cmn_init_dtc() writing 0 to PMCR didn't stop the PMU then we've
> got bigger problems, because that's how we expect to start and stop it
> in normal operation. I'm not ruling out that some subtle bug in that
> regard might exist, since I've still not yet had a chance to reproduce
> and observe this behaviour on my board, but I've also not seen
> sufficient evidence to suggest that that is the case either. (Now that
> I'm looking closely, I think there *is* actually a small oversight for
> the DTMs, but that would lead to different symptoms than you reported)

> At least the writes to PMOVSR_CLR *did* clearly work, because you're
> seeing the "nobody cared" message from the IRQ core rather than the
> WARN_ON(!dtc->counters[i]) which would happen if a fresh overflow was
> actually asserted. Currently I would expect to see up to 4 of those
> messages since there can be up to 4 IRQs, but once those are all
> requested, enabled, and "handled", all the spurious initially-latched
> state should be cleared and any *new* overflows will be indicated in
> PMOVSR. I don't see how a single IRQ could ever be unhandled more than
> once anyway, if the first time disables it.

I do see 4 of these "nobody cared" messages in all the times I've
reproduced it, but saw no need to copy paste all of them in with the
original post. Looking back over the code I see why more clearly your
assertion we only need to clear the DT_EN bit as the PMU is off at
the DTC with the PMCR set to 0 on init, but it is really hard to
see why that is with all the various places bits of configuration is done,
but it is still not easy to verify if unsetting that bit is sufficient to
not get into some odd corner cases.

Is there any argument against me taking another pass and try separating
out discovery, from a shared reset/initialization code path?

-Geoff