Re: [PATCH v3 2/2] soc: qcom: Add Qualcomm Ramp Controller driver

From: Dmitry Baryshkov
Date: Thu Nov 17 2022 - 06:59:47 EST


On Thu, 17 Nov 2022 at 11:12, AngeloGioacchino Del Regno
<angelogioacchino.delregno@xxxxxxxxxxxxx> wrote:
>
> Il 16/11/22 14:46, Dmitry Baryshkov ha scritto:
> > On 15/11/2022 18:45, AngeloGioacchino Del Regno wrote:
> >> The Ramp Controller is used to program the sequence ID for pulse
> >> swallowing, enable sequence and linking sequence IDs for the CPU
> >> cores on some Qualcomm SoCs.
> >>
> >> Signed-off-by: AngeloGioacchino Del Regno <angelogioacchino.delregno@xxxxxxxxxxxxx>
> >> ---
> >> drivers/soc/qcom/Kconfig | 9 +
> >> drivers/soc/qcom/Makefile | 1 +
> >> drivers/soc/qcom/ramp_controller.c | 331 +++++++++++++++++++++++++++++
> >> 3 files changed, 341 insertions(+)
> >> create mode 100644 drivers/soc/qcom/ramp_controller.c
> >>
> >
> > I'd allow myself to re-ask the same questions here:
> >
> > Generic question. regarding this controller. If it is supposed to work
> > close to DVCS, etc. Does ramp controller need any programming when
> > changing speed and/or APC voltage?
> > Is it necessary to turn ramp on and off during the runtime?
> >
>
> No, it's a set-and-forget type of programming. Turning that on/off during
> runtime is self-managed and, after the initial setting that this driver,
> no further action is required - or at least not from Linux.

Ack, thank you!


--
With best wishes
Dmitry