Re: [PATCH net-next v3 0/4] net: lan966x: Add xdp support

[Horatiu Vultur]

The 11/10/2022 17:21, Alexander Lobakin wrote:

Hi,

> 
> From: Andrew Lunn <andrew@xxxxxxx>
> Date: Thu, 10 Nov 2022 14:57:35 +0100
> 
> > > Nice stuff! I hear time to time that XDP is for 10G+ NICs only, but
> > > I'm not a fan of such, and this series proves once again XDP fits
> > > any hardware ^.^
> >
> > The Freescale FEC recently gained XDP support. Many variants of it are
> > Fast Ethernet only.
> >
> > What i found most interesting about that patchset was that the use of
> > the page_ppol API made the driver significantly faster for the general
> > case as well as XDP.
> 
> The driver didn't have any page recycling or page splitting logics,
> while Page Pool recycles even pages from skbs if
> skb_mark_for_recycle() is used, which is the case here. So it
> significantly reduced the number of new page allocations for Rx, if
> there still are any at all.
> Plus, Page Pool allocates pages by bulks (of 16 IIRC), not one by
> one, that reduces CPU overhead as well.

Just to make sure that everything is clear, those results that I have
shown in the cover letter are without any XDP programs on the
interfaces. Because I thought that is the correct comparison of the
results before and after all these changes.

Once I add an XDP program on the interface the performance drops. The
program will look for some ether types and always return XDP_PASS.

These are the results when I have such a XDP program on the interface:
[ ID] Interval           Transfer     Bitrate         Retr
[  5]   0.00-10.01  sec   486 MBytes   408 Mbits/sec    0 sender
[  5]   0.00-10.00  sec   483 MBytes   405 Mbits/sec      receiver

> 
> >
> >      Andrew
> 
> Thanks,
> Olek

-- 
/Horatiu