[PATCH] dt-bindings: nfc: marvell,nci: fix reset line polarity in examples

[Dmitry Torokhov]

The reset line is supposed to be "active low" (it even says so in the
description), but examples incorrectly show it as "active high"
(likely because original examples use 0 which is technically "active
high" but in practice often "don't care" if the driver is using legacy
gpio API, as this one does).

Signed-off-by: Dmitry Torokhov <dmitry.torokhov@xxxxxxxxx>
---
 Documentation/devicetree/bindings/net/nfc/marvell,nci.yaml | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/Documentation/devicetree/bindings/net/nfc/marvell,nci.yaml b/Documentation/devicetree/bindings/net/nfc/marvell,nci.yaml
index a191a04e681c..308485a8ee6c 100644
--- a/Documentation/devicetree/bindings/net/nfc/marvell,nci.yaml
+++ b/Documentation/devicetree/bindings/net/nfc/marvell,nci.yaml
@@ -128,7 +128,7 @@ examples:
 
             i2c-int-rising;
 
-            reset-n-io = <&gpio3 19 GPIO_ACTIVE_HIGH>;
+            reset-n-io = <&gpio3 19 GPIO_ACTIVE_LOW>;
         };
     };
 
@@ -151,7 +151,7 @@ examples:
             interrupt-parent = <&gpio1>;
             interrupts = <17 IRQ_TYPE_EDGE_RISING>;
 
-            reset-n-io = <&gpio3 19 GPIO_ACTIVE_HIGH>;
+            reset-n-io = <&gpio3 19 GPIO_ACTIVE_LOW>;
         };
     };
 
@@ -162,7 +162,7 @@ examples:
         nfc {
             compatible = "marvell,nfc-uart";
 
-            reset-n-io = <&gpio3 16 GPIO_ACTIVE_HIGH>;
+            reset-n-io = <&gpio3 16 GPIO_ACTIVE_LOW>;
 
             hci-muxed;
             flow-control;
-- 
2.38.0.rc1.362.ged0d419d3c-goog


-- 
Dmitry