Re: [PATCH v4 -next] usb: xhci: disable irq during initialization

[谢泓宇]

Hi greg,

On 2022/6/16 16:12, Greg KH wrote:
> On Thu, Jun 16, 2022 at 04:09:33PM +0800, Hongyu Xie wrote:
> > irq is disabled in xhci_quiesce(called by xhci_halt, with bit:2 cleared
> > in USBCMD register), but xhci_run(called by usb_add_hcd) re-enable it.
> > It's possible that you will receive thousands of interrupt requests
> > after initialization for 2.0 roothub. And you will get a lot of
> > warning like, "xHCI dying, ignoring interrupt. Shouldn't IRQs be
> > disabled?". This amount of interrupt requests will cause the entire
> > system to freeze.
> > This problem was first found on a device with ASM2142 host controller
> > on it.
> >
> > Signed-off-by: Hongyu Xie <xiehongyu1@xxxxxxxxxx>
> > Reported-by: kernel test robot <lkp@xxxxxxxxx>
>
> the test robot did not find this original problem, it only found
> problems with your original submission, which is different.
"Reported-by" shouldn't had been put here.
Quote from the last email test robot sent to me，
"If you fix the issue, kindly add following tag where applicable
Reported-by: kernel test robot <lkp@xxxxxxxxx>"
Where should I put this? Or just ignore it?