Re: [PATCH v9 2/3] iommu/mediatek: Rename MTK_IOMMU_TLB_ADDR to MTK_IOMMU_ADDR

[Robin Murphy]

On 2022-06-15 17:12, yf.wang--- via iommu wrote:
> From: Yunfei Wang <yf.wang@xxxxxxxxxxxx>
>
> Rename MTK_IOMMU_TLB_ADDR to MTK_IOMMU_ADDR, and update MTK_IOMMU_ADDR
> definition for better generality.
>
> Signed-off-by: Ning Li <ning.li@xxxxxxxxxxxx>
> Signed-off-by: Yunfei Wang <yf.wang@xxxxxxxxxxxx>
> ---
>   drivers/iommu/mtk_iommu.c | 8 ++++----
>   1 file changed, 4 insertions(+), 4 deletions(-)
>
> diff --git a/drivers/iommu/mtk_iommu.c b/drivers/iommu/mtk_iommu.c
> index bb9dd92c9898..3d62399e8865 100644
> --- a/drivers/iommu/mtk_iommu.c
> +++ b/drivers/iommu/mtk_iommu.c
> @@ -265,8 +265,8 @@ static const struct iommu_ops mtk_iommu_ops;
>   
>   static int mtk_iommu_hw_init(const struct mtk_iommu_data *data, unsigned int bankid);
>   
> -#define MTK_IOMMU_TLB_ADDR(iova) ({					\
> -	dma_addr_t _addr = iova;					\
> +#define MTK_IOMMU_ADDR(addr) ({						\
> +	unsigned long long _addr = addr;				\

If phys_addr_t is 64-bit, then dma_addr_t is also 64-bit, so there is no 
loss of generality from using an appropriate type - IOVAs have to fit 
into dma_addr_t for iommu-dma, after all. However, since IOVAs also have 
to fit into unsigned long in the general IOMMU API, as "addr" is here, 
then this is still just as broken for 32-bit LPAE as the existing code is.

Thanks,
Robin.

>   	((lower_32_bits(_addr) & GENMASK(31, 12)) | upper_32_bits(_addr));\
>   })
>   
> @@ -381,8 +381,8 @@ static void mtk_iommu_tlb_flush_range_sync(unsigned long iova, size_t size,
>   		writel_relaxed(F_INVLD_EN1 | F_INVLD_EN0,
>   			       base + data->plat_data->inv_sel_reg);
>   
> -		writel_relaxed(MTK_IOMMU_TLB_ADDR(iova), base + REG_MMU_INVLD_START_A);
> -		writel_relaxed(MTK_IOMMU_TLB_ADDR(iova + size - 1),
> +		writel_relaxed(MTK_IOMMU_ADDR(iova), base + REG_MMU_INVLD_START_A);
> +		writel_relaxed(MTK_IOMMU_ADDR(iova + size - 1),
>   			       base + REG_MMU_INVLD_END_A);
>   		writel_relaxed(F_MMU_INV_RANGE, base + REG_MMU_INVALIDATE);
>