Re: [PATCH v1 1/1] misc: bcm-vk: add kconfig for supporting viper chip

[Desmond Yan (APD)]

Greg,

This is to allow the customer to use their own driver, by default,
which is their preferred option.

thx
Des


On Fri, Feb 18, 2022 at 11:33 PM Greg Kroah-Hartman
<gregkh@xxxxxxxxxxxxxxxxxxx> wrote:
>
> On Fri, Feb 18, 2022 at 12:08:11PM -0800, Desmond Yan wrote:
> > Add kconfig for enabling bcm-vk driver to support the viper chip.
> > Default is off and only explicitly configured that the viper chip
> > would be discovered by the driver and loaded for usage.
> >
> > Tested-by: Desmond Yan <desmond.yan@xxxxxxxxxxxx>
> > Signed-off-by: Desmond Yan <desmond.yan@xxxxxxxxxxxx>
> > ---
> >  drivers/misc/bcm-vk/Kconfig      | 10 ++++++++++
> >  drivers/misc/bcm-vk/bcm_vk_dev.c |  2 ++
> >  2 files changed, 12 insertions(+)
> >
> > diff --git a/drivers/misc/bcm-vk/Kconfig b/drivers/misc/bcm-vk/Kconfig
> > index 68a972772b99..43910a378163 100644
> > --- a/drivers/misc/bcm-vk/Kconfig
> > +++ b/drivers/misc/bcm-vk/Kconfig
> > @@ -16,6 +16,16 @@ config BCM_VK
> >
> >         If unsure, say N.
> >
> > +config BCM_VK_VIPER
> > +     bool "VK driver for VIPER"
> > +     depends on BCM_VK
> > +     help
> > +       Turn on to enable using the vk driver for the viper variant.
> > +       Used for development environments where viper uses VK driver
> > +       and VK firmware rather than an alternate firmware and driver.
> > +
> > +       If unsure, say N.
> > +
> >  config BCM_VK_TTY
> >       bool "Enable tty ports on a Broadcom VK Accelerator device"
> >       depends on TTY
> > diff --git a/drivers/misc/bcm-vk/bcm_vk_dev.c b/drivers/misc/bcm-vk/bcm_vk_dev.c
> > index ad639ee85b2a..41dbfa4fa4a5 100644
> > --- a/drivers/misc/bcm-vk/bcm_vk_dev.c
> > +++ b/drivers/misc/bcm-vk/bcm_vk_dev.c
> > @@ -1633,7 +1633,9 @@ static void bcm_vk_shutdown(struct pci_dev *pdev)
> >
> >  static const struct pci_device_id bcm_vk_ids[] = {
> >       { PCI_DEVICE(PCI_VENDOR_ID_BROADCOM, PCI_DEVICE_ID_VALKYRIE), },
> > +#if defined(CONFIG_BCM_VK_VIPER)
> >       { PCI_DEVICE(PCI_VENDOR_ID_BROADCOM, PCI_DEVICE_ID_VIPER), },
> > +#endif
>
> Why do you need a new config option just to add a new device id?  Why
> would you ever NOT want this option enabled as there is no other driver
> for this hardware?
>
> thanks,
>
> greg k-h

Attachment: smime.p7s
Description: S/MIME Cryptographic Signature