[PATCH 4/9] serial: sc16is7xx: remove redundant code in rs485_config

[Lino Sanfilippo]

When RS485 is configured by userspace the serial core already checks for
valid RTS settings. So remove the check from the implementation of the
sc16is7xx drivers rs485_config function to avoid redundancy.

Signed-off-by: Lino Sanfilippo <LinoSanfilippo@xxxxxx>
---
 drivers/tty/serial/sc16is7xx.c | 10 ----------
 1 file changed, 10 deletions(-)

diff --git a/drivers/tty/serial/sc16is7xx.c b/drivers/tty/serial/sc16is7xx.c
index 64e7e6c8145f..730f697bb517 100644
--- a/drivers/tty/serial/sc16is7xx.c
+++ b/drivers/tty/serial/sc16is7xx.c
@@ -959,16 +959,6 @@ static int sc16is7xx_config_rs485(struct uart_port *port,
 	struct sc16is7xx_one *one = to_sc16is7xx_one(port, port);
 
 	if (rs485->flags & SER_RS485_ENABLED) {
-		bool rts_during_rx, rts_during_tx;
-
-		rts_during_rx = rs485->flags & SER_RS485_RTS_AFTER_SEND;
-		rts_during_tx = rs485->flags & SER_RS485_RTS_ON_SEND;
-
-		if (rts_during_rx == rts_during_tx)
-			dev_err(port->dev,
-				"unsupported RTS signalling on_send:%d after_send:%d - exactly one of RS485 RTS flags should be set\n",
-				rts_during_tx, rts_during_rx);
-
 		/*
 		 * RTS signal is handled by HW, it's timing can't be influenced.
 		 * However, it's sometimes useful to delay TX even without RTS
-- 
2.34.1