Re: [PATCH 2/3] i2c: sh_mobile: Use platform_get_irq_optional() to get the interrupt

[Sergei Shtylyov]

On 2/9/22 7:02 PM, Arnd Bergmann wrote:

>>>>> since 2009 after 1e1030dccb10 ("sh: nmi_debug support."). On a
>>>>
>>>>    Mhm... this commit changes the SH3 code while SH778x are SH4A, no?
>>>
>>> This code is shared between both:
>>>
>>> arch/sh/kernel/cpu/sh4/Makefile:common-y        += $(addprefix
>>> ../sh3/, entry.o ex.o)
>>
>>    Ah, quite convoluted! :-)
>>    So you mean thet broke the delivery of EVT 0x200 when mucking with NMI?
> 
> Yes, exactly: If I read this right, the added code:
> 
> +       shlr2   r4
> +       shlr    r4
> +       mov     r4, r0          ! save vector->jmp table offset for later
> +
> +       shlr2   r4              ! vector to IRQ# conversion
> +       add     #-0x10, r4
> +
> +       cmp/pz  r4              ! is it a valid IRQ?
> +       bt      10f
> 
> gets the vector (0x200 for this device), shifts it five bits to 0x10,
> and subtracts 0x10,
> then branches to do_IRQ if the interrupt number is non-zero, otherwise it goes
> through the exception_handling_table.

   The SH4 manual I found on my disk (have it from MontaVista times) tells me cmp/pz
sets T if Rn is >= 0, then bt branches if T = 1. So I do think the code is correct.
   One more thing: the board code for those boards was added in 2011, we can assume
it was working back then, right? :-_

>          Arnd

MBR, Sergey