Re: [PATCH v6 1/2] wilc1000: Add reset/enable GPIO support to SPI driver

[Kalle Valo]

David Mosberger-Tang <davidm@xxxxxxxxxx> wrote:

> For the SDIO driver, the RESET/ENABLE pins of WILC1000 are controlled
> through the SDIO power sequence driver.  This commit adds analogous
> support for the SPI driver.  Specifically, during initialization, the
> chip will be ENABLEd and taken out of RESET and during
> deinitialization, the chip will be placed back into RESET and disabled
> (both to reduce power consumption and to ensure the WiFi radio is
> off).
> 
> Both RESET and ENABLE GPIOs are optional.  However, if the ENABLE GPIO
> is specified, then the RESET GPIO should normally also be specified as
> otherwise there is no way to ensure proper timing of the ENABLE/RESET
> sequence.
> 
> Signed-off-by: David Mosberger-Tang <davidm@xxxxxxxxxx>

Failed to apply, please rebase on top of wireless-drivers-next.

error: sha1 information is lacking or useless (drivers/net/wireless/microchip/wilc1000/wlan.c).
error: could not build fake ancestor
hint: Use 'git am --show-current-patch' to see the failed patch
Applying: wilc1000: Add reset/enable GPIO support to SPI driver
Patch failed at 0001 wilc1000: Add reset/enable GPIO support to SPI driver

2 patches set to Changes Requested.

12688345 [v6,1/2] wilc1000: Add reset/enable GPIO support to SPI driver
12688343 [v6,2/2] wilc1000: Document enable-gpios and reset-gpios properties

-- 
https://patchwork.kernel.org/project/linux-wireless/patch/20211220180334.3990693-2-davidm@xxxxxxxxxx/

https://wireless.wiki.kernel.org/en/developers/documentation/submittingpatches