Re: [PATCH 13/13] extcon: intel-cht-wc: Add support for devices with an USB-micro-B connector

[Hans de Goede]

Hi,

On 10/31/21 13:52, Andy Shevchenko wrote:
> On Sat, Oct 30, 2021 at 9:29 PM Hans de Goede <hdegoede@xxxxxxxxxx> wrote:
>>
>> So far the extcon-intel-cht-wc code has only been tested on devices with
>> a Type-C connector with USB-PD, USB3 (superspeed) and DP-altmode support
>> through a FUSB302 Type-C controller.
>>
>> Some devices with the intel-cht-wc PMIC however come with an USB-micro-B
>> connector, or an USB-2 only Type-C connector without USB-PD.
>>
>> These device are identified by "intel,cht-wc-setup" = "bq25890,bq27520",
>> since there is no Type-C controller on these devices the extcon code must
>> control the Vbus 5V boost converter and the USB role switch depending on
>> the detected cable-type.
> 
> ...
> 
>> +       if (ext->vbus_boost && ext->vbus_boost_enabled != enable) {
>> +               if (enable)
>> +                       ret = regulator_enable(ext->vbus_boost);
>> +               else
>> +                       ret = regulator_disable(ext->vbus_boost);
> 
>> +               if (ret == 0)
>> +                       ext->vbus_boost_enabled = enable;
>> +               else
>> +                       dev_err(ext->dev, "Error updating Vbus boost regulator: %d\n", ret);
> 
> if (ret)
>  dev_err()
> else
>  ...
> 
> ?

When doing if-else branches around an error code I always put the success
handling in the if branch and have the else branch deal with the error
to me that feels as the most natural way to do it the error is the exception
and thus the "else"

> 
>> +       }
> 
> ...
> 
> 
>> +               /*
>> +                * Classic micro USB-B setup, this requires controling
> 
> controlling

Fixed for the next version.

Thanks & Regards,

Hans


> 
>> +                * the role-sw and vbus based on the id-pin.
>> +                */
>