[PATCH v1] usb: xhci: add LPM quirk for ensuring uPD720201 into D3 state after S5

From: Yinbo Zhu
Date: Mon Nov 01 2021 - 03:17:27 EST


After S5, any pci device should into D3 state that if supported, but the
uPD720201 was not and it may be the cause of xhci firmware and cause
OSPM power consumption is more higher that S5 than S4. I think xhci HCD
can add a quirk ensure it into D3 state after S5 that is appropriate
and this patch was to add LPM quirk and set PCI_D3hot to uPD720201 pmsc
register in xhci_pci_shutdown to fix xhci power consumption issue.

Signed-off-by: Yinbo Zhu <zhuyinbo@xxxxxxxxxxx>
---
drivers/usb/host/xhci-pci.c | 4 +++-
drivers/usb/host/xhci.h | 1 +
2 files changed, 4 insertions(+), 1 deletion(-)

diff --git a/drivers/usb/host/xhci-pci.c b/drivers/usb/host/xhci-pci.c
index 2c9f25c..f97bb64 100644
--- a/drivers/usb/host/xhci-pci.c
+++ b/drivers/usb/host/xhci-pci.c
@@ -265,6 +265,7 @@ static void xhci_pci_quirks(struct device *dev, struct xhci_hcd *xhci)
pdev->device == 0x0014) {
xhci->quirks |= XHCI_TRUST_TX_LENGTH;
xhci->quirks |= XHCI_ZERO_64B_REGS;
+ xhci->quirks |= XHCI_LPM_QUIRK;
}
if (pdev->vendor == PCI_VENDOR_ID_RENESAS &&
pdev->device == 0x0015) {
@@ -608,7 +609,8 @@ static void xhci_pci_shutdown(struct usb_hcd *hcd)
xhci_shutdown(hcd);

/* Yet another workaround for spurious wakeups at shutdown with HSW */
- if (xhci->quirks & XHCI_SPURIOUS_WAKEUP)
+ if (xhci->quirks & XHCI_SPURIOUS_WAKEUP ||
+ xhci->quirks & XHCI_LPM_QUIRK)
pci_set_power_state(pdev, PCI_D3hot);
}
#endif /* CONFIG_PM */
diff --git a/drivers/usb/host/xhci.h b/drivers/usb/host/xhci.h
index dca6181..5f790202 100644
--- a/drivers/usb/host/xhci.h
+++ b/drivers/usb/host/xhci.h
@@ -1899,6 +1899,7 @@ struct xhci_hcd {
#define XHCI_SG_TRB_CACHE_SIZE_QUIRK BIT_ULL(39)
#define XHCI_NO_SOFT_RETRY BIT_ULL(40)
#define XHCI_BROKEN_D3COLD BIT_ULL(41)
+#define XHCI_LPM_QUIRK BIT_ULL(42)

unsigned int num_active_eps;
unsigned int limit_active_eps;
--
1.8.3.1