[PATCH 1/2] arm/arm64: dts: Enable 2.5G Ethernet port on CN9130-CRB

[Chris Packham]

Enable the 2.5G Ethernet port by setting the status to "okay" and the
phy-mode to "2500base-x" on the cn9130-crb boards. Tested on a
CN9130-CRB-A.

Signed-off-by: Chris Packham <chris.packham@xxxxxxxxxxxxxxxxxxx>
---

The Marvell SDK adds 2500base-t and uses it in the equivalent dtsi but
looking at the documentation for both the SoC and the PHY I think
2500base-x is correct for the system interface (the line side is
2500base-t).

 arch/arm64/boot/dts/marvell/cn9130-crb.dtsi | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/arch/arm64/boot/dts/marvell/cn9130-crb.dtsi b/arch/arm64/boot/dts/marvell/cn9130-crb.dtsi
index 505ae69289f6..e7918f325646 100644
--- a/arch/arm64/boot/dts/marvell/cn9130-crb.dtsi
+++ b/arch/arm64/boot/dts/marvell/cn9130-crb.dtsi
@@ -214,8 +214,8 @@ &cp0_eth1 {
 };
 
 &cp0_eth2 {
-	/* This port uses "2500base-t" phy-mode */
-	status = "disabled";
+	status = "okay";
+	phy-mode = "2500base-x";
 	phy = <&nbaset_phy0>;
 	phys = <&cp0_comphy5 2>;
 };
-- 
2.33.0