Re: [PATCH] PCI/portdrv: Do not setup up IRQs if there are no users

[Lukas Wunner]

On Fri, Aug 20, 2021 at 03:52:18PM +0200, Jan Kiszka wrote:
> --- a/drivers/pci/pcie/portdrv_core.c
> +++ b/drivers/pci/pcie/portdrv_core.c
> @@ -312,7 +312,7 @@ static int pcie_device_init(struct pci_dev *pdev, int service, int irq)
>   */
>  int pcie_port_device_register(struct pci_dev *dev)
>  {
> -	int status, capabilities, i, nr_service;
> +	int status, capabilities, irq_services, i, nr_service;
>  	int irqs[PCIE_PORT_DEVICE_MAXSERVICES];
>  
>  	/* Enable PCI Express port device */
> @@ -326,18 +326,32 @@ int pcie_port_device_register(struct pci_dev *dev)
>  		return 0;
>  
>  	pci_set_master(dev);
> -	/*
> -	 * Initialize service irqs. Don't use service devices that
> -	 * require interrupts if there is no way to generate them.
> -	 * However, some drivers may have a polling mode (e.g. pciehp_poll_mode)
> -	 * that can be used in the absence of irqs.  Allow them to determine
> -	 * if that is to be used.
> -	 */
> -	status = pcie_init_service_irqs(dev, irqs, capabilities);
> -	if (status) {
> -		capabilities &= PCIE_PORT_SERVICE_HP;
> -		if (!capabilities)
> -			goto error_disable;
> +
> +	irq_services = 0;
> +	if (IS_ENABLED(CONFIG_PCIE_PME))
> +		irq_services |= PCIE_PORT_SERVICE_PME;
> +	if (IS_ENABLED(CONFIG_PCIEAER))
> +		irq_services |= PCIE_PORT_SERVICE_AER;
> +	if (IS_ENABLED(CONFIG_HOTPLUG_PCI_PCIE))
> +		irq_services |= PCIE_PORT_SERVICE_HP;
> +	if (IS_ENABLED(CONFIG_PCIE_DPC))
> +		irq_services |= PCIE_PORT_SERVICE_DPC;
> +	irq_services &= capabilities;

get_port_device_capability() would seem like a more natural place
to put these checks.

Note that your check for CONFIG_PCIEAER is superfluous due to
the "#ifdef CONFIG_PCIEAER" in get_port_device_capability().

Thanks,

Lukas