[PATCH 16/16] iio: adc: max1027: Enable software triggers to be used without IRQ

[Miquel Raynal]

Software triggers do not need a device IRQ to work. As opposed to
hardware triggers which need it to yield the data to the IIO core,
software triggers run a dedicated thread which does all the tasks on
their behalf. Then, the end of conversion status may either come from an
interrupt or from a sufficient enough extra delay. IRQs are not
mandatory so move the triggered buffer setup out of the IRQ condition.

Signed-off-by: Miquel Raynal <miquel.raynal@xxxxxxxxxxx>
---
 drivers/iio/adc/max1027.c | 20 +++++++++++---------
 1 file changed, 11 insertions(+), 9 deletions(-)

diff --git a/drivers/iio/adc/max1027.c b/drivers/iio/adc/max1027.c
index bb437e43adaf..e767437a578e 100644
--- a/drivers/iio/adc/max1027.c
+++ b/drivers/iio/adc/max1027.c
@@ -567,16 +567,18 @@ static int max1027_probe(struct spi_device *spi)
 	if (!st->buffer)
 		return -ENOMEM;
 
+	/* Enable triggered buffers */
+	ret = devm_iio_triggered_buffer_setup(&spi->dev, indio_dev,
+					      &iio_pollfunc_store_time,
+					      &max1027_trigger_handler,
+					      NULL);
+	if (ret < 0) {
+		dev_err(&indio_dev->dev, "Failed to setup buffer\n");
+		return ret;
+	}
+
+	/* If there is an EOC interrupt, enable the hardware trigger (cnvst) */
 	if (spi->irq) {
-		ret = devm_iio_triggered_buffer_setup(&spi->dev, indio_dev,
-						      &iio_pollfunc_store_time,
-						      &max1027_trigger_handler,
-						      NULL);
-		if (ret < 0) {
-			dev_err(&indio_dev->dev, "Failed to setup buffer\n");
-			return ret;
-		}
-
 		st->trig = devm_iio_trigger_alloc(&spi->dev, "%s-trigger",
 						  indio_dev->name);
 		if (st->trig == NULL) {
-- 
2.27.0