[PATCH] net: dsa: lantiq_gswip: Add 200ms assert delay

[Aleksander Jan Bajkowski]

The delay is especially needed by the xRX300 and xRX330 SoCs. Without
this patch, some phys are sometimes not properly detected.

Fixes: a09d042b086202735c4ed64 ("net: dsa: lantiq: allow to use all GPHYs on xRX300 and xRX330")
Signed-off-by: Martin Blumenstingl <martin.blumenstingl@xxxxxxxxxxxxxx>
Tested-by: Aleksander Jan Bajkowski <olek2@xxxxx> # tested on DWR966, HH5A
---
 drivers/net/dsa/lantiq_gswip.c | 6 ++++++
 1 file changed, 6 insertions(+)

diff --git a/drivers/net/dsa/lantiq_gswip.c b/drivers/net/dsa/lantiq_gswip.c
index e78026ef6d8c..9eaf013b82a3 100644
--- a/drivers/net/dsa/lantiq_gswip.c
+++ b/drivers/net/dsa/lantiq_gswip.c
@@ -1884,6 +1884,12 @@ static int gswip_gphy_fw_load(struct gswip_priv *priv, struct gswip_gphy_fw *gph
 
 	reset_control_assert(gphy_fw->reset);
 
+	/* The vendor BSP uses a 200ms delay after asserting the reset line.
+	 * Without this some users are observing that the PHY is not coming up
+	 * on the MDIO bus.
+	 */
+	msleep(200);
+
 	ret = request_firmware(&fw, gphy_fw->fw_name, dev);
 	if (ret) {
 		dev_err(dev, "failed to load firmware: %s, error: %i\n",
-- 
2.30.2