[PATCH] signal/x86: Don't send SIGSEGV twice on SEGV_PKUERR

[Jiashuo Liang]

Before this patch, the __bad_area_nosemaphore function calls both
force_sig_pkuerr and force_sig_fault when handling SEGV_PKUERR. This does
not cause problems because the second signal is filtered by the
legacy_queue check in __send_signal. But it causes the kernel to do
unnecessary work.

This patch should fix it.

Fixes: 9db812dbb29d ("signal/x86: Call force_sig_pkuerr from __bad_area_nosemaphore")
Suggested-by: "Eric W. Biederman" <ebiederm@xxxxxxxxxxxx>
Signed-off-by: Jiashuo Liang <liangjs@xxxxxxxxxx>
---
 arch/x86/mm/fault.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/arch/x86/mm/fault.c b/arch/x86/mm/fault.c
index 1c548ad00752..6bda7f67d737 100644
--- a/arch/x86/mm/fault.c
+++ b/arch/x86/mm/fault.c
@@ -836,8 +836,8 @@ __bad_area_nosemaphore(struct pt_regs *regs, unsigned long error_code,
 
 	if (si_code == SEGV_PKUERR)
 		force_sig_pkuerr((void __user *)address, pkey);
-
-	force_sig_fault(SIGSEGV, si_code, (void __user *)address);
+	else
+		force_sig_fault(SIGSEGV, si_code, (void __user *)address);
 
 	local_irq_disable();
 }
-- 
2.31.1