[PATCH net-next 1/9] net: wan: remove leading spaces before tabs

From: Hui Tang
Date: Wed May 19 2021 - 23:51:08 EST


There are a few leading spaces before tabs and remove it by running
the following commard:

$ find . -name '*.[ch]' | xargs sed -r -i 's/^[ ]+\t/\t/'

Cc: Xie He <xie.he.0141@xxxxxxxxx>
Signed-off-by: Hui Tang <tanghui20@xxxxxxxxxx>
---
drivers/net/wan/lmc/lmc.h | 2 +-
drivers/net/wan/wanxl.c | 4 ++--
drivers/net/wan/z85230.c | 8 ++++----
3 files changed, 7 insertions(+), 7 deletions(-)

diff --git a/drivers/net/wan/lmc/lmc.h b/drivers/net/wan/lmc/lmc.h
index 3896179..3bd541c 100644
--- a/drivers/net/wan/lmc/lmc.h
+++ b/drivers/net/wan/lmc/lmc.h
@@ -9,7 +9,7 @@
*/
int lmc_probe(struct net_device * dev);
unsigned lmc_mii_readreg(lmc_softc_t * const sc, unsigned
- devaddr, unsigned regno);
+ devaddr, unsigned regno);
void lmc_mii_writereg(lmc_softc_t * const sc, unsigned devaddr,
unsigned regno, unsigned data);
void lmc_led_on(lmc_softc_t * const, u32);
diff --git a/drivers/net/wan/wanxl.c b/drivers/net/wan/wanxl.c
index a831333..f393684 100644
--- a/drivers/net/wan/wanxl.c
+++ b/drivers/net/wan/wanxl.c
@@ -639,7 +639,7 @@ static int wanxl_pci_init_one(struct pci_dev *pdev,
card->plx = ioremap(plx_phy, 0x70);
if (!card->plx) {
pr_err("ioremap() failed\n");
- wanxl_pci_remove_one(pdev);
+ wanxl_pci_remove_one(pdev);
return -EFAULT;
}

@@ -707,7 +707,7 @@ static int wanxl_pci_init_one(struct pci_dev *pdev,
mem = ioremap(mem_phy, PDM_OFFSET + sizeof(firmware));
if (!mem) {
pr_err("ioremap() failed\n");
- wanxl_pci_remove_one(pdev);
+ wanxl_pci_remove_one(pdev);
return -EFAULT;
}

diff --git a/drivers/net/wan/z85230.c b/drivers/net/wan/z85230.c
index 138930c..002b8c99 100644
--- a/drivers/net/wan/z85230.c
+++ b/drivers/net/wan/z85230.c
@@ -1080,7 +1080,7 @@ int z8530_sync_txdma_open(struct net_device *dev, struct z8530_channel *c)
z8530_rx_done(c);
z8530_rx_done(c);

- /*
+ /*
* Load the DMA interfaces up
*/

@@ -1092,13 +1092,13 @@ int z8530_sync_txdma_open(struct net_device *dev, struct z8530_channel *c)
c->dma_ready=1;
c->dma_tx = 1;

- /*
+ /*
* Enable DMA control mode
*/

- /*
+ /*
* TX DMA via DIR/REQ
- */
+ */
c->regs[R14]|= DTRREQ;
write_zsreg(c, R14, c->regs[R14]);

--
2.8.1