Re: [PATCH] usb: typec: ucsi: Clear pending after acking connector change

[Heikki Krogerus]

On Mon, May 17, 2021 at 02:57:28PM +0200, Benjamin Berg wrote:
> Hi Heikki,
> 
> 
> On Mon, 2021-05-17 at 15:15 +0300, Heikki Krogerus wrote:
> > On Mon, May 17, 2021 at 01:03:12PM +0300, Heikki Krogerus wrote:
> > > On Sat, May 15, 2021 at 09:09:53PM -0700, Bjorn Andersson wrote:
> > > > It's possible that the interrupt handler for the UCSI driver
> > > > signals a
> > > > connector changes after the handler clears the PENDING bit, but
> > > > before
> > > > it has sent the acknowledge request. The result is that the handler
> > > > is
> > > > invoked yet again, to ack the same connector change.
> > > > 
> > > > At least some versions of the Qualcomm UCSI firmware will not
> > > > handle the
> > > > second - "spurious" - acknowledgment gracefully. So make sure to
> > > > not
> > > > clear the pending flag until the change is acknowledged.
> > > > 
> > > > Any connector changes coming in after the acknowledgment, that
> > > > would
> > > > have the pending flag incorrectly cleared, would afaict be covered
> > > > by
> > > > the subsequent connector status check.
> > > > 
> > > > Fixes: 217504a05532 ("usb: typec: ucsi: Work around PPM losing
> > > > change information")
> > > > Signed-off-by: Bjorn Andersson <bjorn.andersson@xxxxxxxxxx>
> > > 
> > > I'm OK with this if Bejamin does not see any problems with it. I'll
> > > wait for his comments before giving my reviewed-by tag.
> > > 
> > > That workaround (commit 217504a05532) is unfortunately too fragile.
> > > I'm going to now separate the processing of the connector state from
> > > the event handler (interrupt handler). That way we should be fairly
> > > sure we don't loose any of the connector states even if an event is
> > > generated while we are still in the middle of processing the previous
> > > one(s), and at the same time be sure that we also don't confuse the
> > > firmware.
> > > 
> > > So the event handler shall after that only read the connector status,
> > > schedule the unique job where it's processed and ACK the event.
> > > Nothing else.
> > 
> > Seems to be straightforward to implement. I'm attaching the patch I
> > made for that. I think it should actually also remove the problem you
> > are seeing. Can you test it?
> 
> Hmm, I am happy to try the patch tomorrow in the scenario where I
> observed my race condition.
> 
> Unfortunately, I don't feel it'll work. The problem that I was seeing
> looked like a race condition in the PPM itself, where the window is the
> time between the UCSI_GET_CONNECTOR_STATUS command and the subsequent
> ACK.
> For such a firmware level bug in the PPM, we need a way to detect the
> race condition when it happens (or get a fix for the firmware).

OK. Let me know does the patch bring the issue back for you.

> Note that there was also some code to always sent a
> UCSI_GET_CAM_SUPPORTED command "to ensure the PPM does not get stuck in
> case it assumes we do". I have no idea where this came from or what
> PPMs might require this workaround. But I doubt it is a good idea to
> drop it.

Sure.

thanks,

-- 
heikki