RE: [PATCH 2/3] fpga: region: Add fpga-region property 'power-domains'

[Nava kishore Manne]

Hi Moritz,

	Thanks for the response.
Please find my response inline.

> -----Original Message-----
> From: Moritz Fischer <mdf@xxxxxxxxxx>
> Sent: Friday, April 2, 2021 10:46 PM
> To: Nava kishore Manne <navam@xxxxxxxxxx>
> Cc: mdf@xxxxxxxxxx; trix@xxxxxxxxxx; robh+dt@xxxxxxxxxx; Michal Simek
> <michals@xxxxxxxxxx>; linux-fpga@xxxxxxxxxxxxxxx;
> devicetree@xxxxxxxxxxxxxxx; linux-kernel@xxxxxxxxxxxxxxx; linux-arm-
> kernel@xxxxxxxxxxxxxxxxxxx; git <git@xxxxxxxxxx>
> Subject: Re: [PATCH 2/3] fpga: region: Add fpga-region property 'power-
> domains'
> 
> On Fri, Apr 02, 2021 at 02:50:48PM +0530, Nava kishore Manne wrote:
> > Add fpga-region property 'power-domains' to allow to handle the
> > FPGA/PL power domins.
> >
> > dt-bindings: fpga: Enable PM generic domain support
> >
> > Signed-off-by: Nava kishore Manne <nava.manne@xxxxxxxxxx>
> > ---
> >  .../devicetree/bindings/fpga/fpga-region.txt       | 14 ++++++++++++++
> >  1 file changed, 14 insertions(+)
> >
> > diff --git a/Documentation/devicetree/bindings/fpga/fpga-region.txt
> > b/Documentation/devicetree/bindings/fpga/fpga-region.txt
> > index e811cf825019..969ca53bb65e 100644
> > --- a/Documentation/devicetree/bindings/fpga/fpga-region.txt
> > +++ b/Documentation/devicetree/bindings/fpga/fpga-region.txt
> > @@ -196,6 +196,20 @@ Optional properties:
> >  - config-complete-timeout-us : The maximum time in microseconds time
> for the
> >  	FPGA to go to operating mode after the region has been
> programmed.
> >  - child nodes : devices in the FPGA after programming.
> > +- power-domains : A phandle and PM domain specifier as defined by
> bindings of
> > +	the power controller specified by phandle.
> > +Example:
> > +	fpga_full: fpga-full {
> > +                compatible = "fpga-region";
> > +                fpga-mgr = <&zynqmp_pcap>;
> > +                #address-cells = <2>;
> > +                #size-cells = <2>;
> > +                ranges;
> > +                power-domains = <&zynqmp_firmware PL_PD>;
> > +        };
> > +
> > +	The PL_PD power domain will be turned on before loading the
> > +bitstream and turned off while removing/unloading the bitstream using
> overlays.
> 
> Can multiple regions share a power-domain or is this specific to full fpga
> reconfiguration?
> 

These are generic changes and not limited to full region. If H/W supports individual power domains to control the Partial reconfiguration regions we can control the individual Partial reconfiguration region power domains as well.

Regards,
Navakishore.