Re: [RFC PATCH] USB:XHCI:Modify XHCI driver for USB2.0 controller

[liulongfang]

On 2021/2/28 0:27, Alan Stern Wrote:
> On Sat, Feb 27, 2021 at 11:38:08AM +0800, liulongfang wrote:
>> On 2021/2/27 0:30, Alan Stern wrote:
>>> On Fri, Feb 26, 2021 at 04:21:37PM +0800, Longfang Liu wrote:
>>>> Our current XHCI hardware controller has been customized to only
>>>> support USB 2.0 ports. When using the current xhci driver, an xhci
>>>> controller device and an ehci controller device will be created
>>>> automatically.
>>>
>>> That sentence makes no sense at all.  An EHCI controller device is a 
>>> piece of hardware.  How can an xHCI driver, which is a piece of 
>>> software, create a piece of hardware?
>>>
>>> Alan Stern
>>> .
>>>
>> The hardware device is a complete USB3.0 controller,
>> but I hope to support a USB2.0-only mode through software configuration.
> 
> Even if it only supports USB-2.0 connections, an xHCI controller is 
> still an xHCI controller.  It doesn't magically transform into an EHCI 
> controller.
> 
> You are not creating an EHCI controller device.  Rather, you are trying 
> to restrict an xHCI controller device to make it handle only USB-2.0 
> connections.  If you run lsusb on a system that has an xHCI controller, 
> you'll see that the controller is bound to two USB buses: a USB-2 bus 
> and a USB-3 bus.  But for both buses, the controller is xHCI -- not 
> EHCI.
> 
> Your patch description is inaccurate.
> 
> Alan Stern
> .
> 
Yes, you are right.
when I run lsusb on a system that has this xHCI hardware,
the system displays two USB buses: a USB-2 bus and a USB-3 bus.
Both of these are xHCI host controllers, but USB-3 bus's roothub is zero.
Thanks.
Longfang Liu.