Re: [PATCH 4/7] spi: spi-geni-qcom: Add support for GPI dma

From: Dmitry Baryshkov
Date: Thu Feb 04 2021 - 16:35:41 EST


On 11/01/2021 18:16, Vinod Koul wrote:
We can use GPI DMA for devices where it is enabled by firmware. Add
support for this mode

Signed-off-by: Vinod Koul <vkoul@xxxxxxxxxx>
---
drivers/spi/spi-geni-qcom.c | 395 +++++++++++++++++++++++++++++++++++-
1 file changed, 384 insertions(+), 11 deletions(-)

diff --git a/drivers/spi/spi-geni-qcom.c b/drivers/spi/spi-geni-qcom.c
index 512e925d5ea4..5bb0e2192734 100644
--- a/drivers/spi/spi-geni-qcom.c
+++ b/drivers/spi/spi-geni-qcom.c

[skipped]

@@ -328,8 +609,34 @@ static int spi_geni_init(struct spi_geni_master *mas)
spi_tx_cfg &= ~CS_TOGGLE;
writel(spi_tx_cfg, se->base + SE_SPI_TRANS_CFG);
+ mas->tx = dma_request_slave_channel(mas->dev, "tx");
+ if (IS_ERR_OR_NULL(mas->tx)) {

dma_request_slave_channel() is deprecated. Also it does not return an actualy error, it always returns NULL. So the error path here is bugged.
Judging from the rest of the driver, it might be logical to select the transfer mode at the probe time, then it would be possible to skip checking for DMA channels if FIFO mode is selected.

+ dev_err(mas->dev, "Failed to get tx DMA ch %ld", PTR_ERR(mas->tx));
+ ret = PTR_ERR(mas->tx);
+ goto out_pm;
+ } else {
+ mas->rx = dma_request_slave_channel(mas->dev, "rx");
+ if (IS_ERR_OR_NULL(mas->rx)) {
+ dev_err(mas->dev, "Failed to get rx DMA ch %ld", PTR_ERR(mas->rx));
+ dma_release_channel(mas->tx);
+ ret = PTR_ERR(mas->rx);
+ goto out_pm;
+ }
+
+ gsi_sz = sizeof(struct spi_geni_gsi) * NUM_SPI_XFER;
+ mas->gsi = devm_kzalloc(mas->dev, gsi_sz, GFP_KERNEL);
+ if (IS_ERR_OR_NULL(mas->gsi)) {
+ dma_release_channel(mas->tx);
+ dma_release_channel(mas->rx);
+ mas->tx = NULL;
+ mas->rx = NULL;
+ goto out_pm;
+ }
+ }
+
+out_pm:
pm_runtime_put(mas->dev);
- return 0;
+ return ret;
}
static unsigned int geni_byte_per_fifo_word(struct spi_geni_master *mas)
@@ -420,6 +727,7 @@ static void setup_fifo_xfer(struct spi_transfer *xfer,
{
u32 m_cmd = 0;
u32 len;
+ u32 m_param = 0;
struct geni_se *se = &mas->se;
int ret;
@@ -457,6 +765,11 @@ static void setup_fifo_xfer(struct spi_transfer *xfer,
len = xfer->len / (mas->cur_bits_per_word / BITS_PER_BYTE + 1);
len &= TRANS_LEN_MSK;
+ if (!xfer->cs_change) {
+ if (!list_is_last(&xfer->transfer_list, &spi->cur_msg->transfers))
+ m_param |= FRAGMENTATION;
+ }
+
mas->cur_xfer = xfer;
if (xfer->tx_buf) {
m_cmd |= SPI_TX_ONLY;
@@ -475,7 +788,7 @@ static void setup_fifo_xfer(struct spi_transfer *xfer,
* interrupt could come in at any time now.
*/
spin_lock_irq(&mas->lock);
- geni_se_setup_m_cmd(se, m_cmd, FRAGMENTATION);
+ geni_se_setup_m_cmd(se, m_cmd, m_param);
/*
* TX_WATERMARK_REG should be set after SPI configuration and
@@ -494,13 +807,52 @@ static int spi_geni_transfer_one(struct spi_master *spi,
struct spi_transfer *xfer)
{
struct spi_geni_master *mas = spi_master_get_devdata(spi);
+ unsigned long timeout, jiffies;
+ int ret = 0i, i;
/* Terminate and return success for 0 byte length transfer */
if (!xfer->len)
- return 0;
+ return ret;
+
+ if (mas->cur_xfer_mode == GENI_SE_FIFO) {
+ setup_fifo_xfer(xfer, mas, slv->mode, spi);
+ } else {
+ setup_gsi_xfer(xfer, mas, slv, spi);
+ if (mas->num_xfers >= NUM_SPI_XFER ||
+ (list_is_last(&xfer->transfer_list, &spi->cur_msg->transfers))) {
+ for (i = 0 ; i < mas->num_tx_eot; i++) {
+ jiffies = msecs_to_jiffies(SPI_XFER_TIMEOUT_MS);
+ timeout = wait_for_completion_timeout(&mas->tx_cb, jiffies);
+ if (timeout <= 0) {
+ dev_err(mas->dev, "Tx[%d] timeout%lu\n", i, timeout);
+ ret = -ETIMEDOUT;
+ goto err_gsi_geni_transfer_one;
+ }
+ spi_finalize_current_transfer(spi);
+ }
+ for (i = 0 ; i < mas->num_rx_eot; i++) {
+ jiffies = msecs_to_jiffies(SPI_XFER_TIMEOUT_MS);
+ timeout = wait_for_completion_timeout(&mas->tx_cb, jiffies);
+ if (timeout <= 0) {
+ dev_err(mas->dev, "Rx[%d] timeout%lu\n", i, timeout);
+ ret = -ETIMEDOUT;
+ goto err_gsi_geni_transfer_one;
+ }
+ spi_finalize_current_transfer(spi);
+ }
+ if (mas->qn_err) {
+ ret = -EIO;
+ mas->qn_err = false;
+ goto err_gsi_geni_transfer_one;
+ }
+ }
+ }
- setup_fifo_xfer(xfer, mas, slv->mode, spi);
- return 1;
+ return ret;
+
+err_gsi_geni_transfer_one:
+ dmaengine_terminate_all(mas->tx);
+ return ret;
}
static irqreturn_t geni_spi_isr(int irq, void *data)
@@ -595,6 +947,15 @@ static int spi_geni_probe(struct platform_device *pdev)
if (irq < 0)
return irq;
+ ret = dma_set_mask_and_coherent(&pdev->dev, DMA_BIT_MASK(64));
+ if (ret) {
+ ret = dma_set_mask_and_coherent(&pdev->dev, DMA_BIT_MASK(32));
+ if (ret) {
+ dev_err(&pdev->dev, "could not set DMA mask\n");
+ return ret;
+ }
+ }
+
base = devm_platform_ioremap_resource(pdev, 0);
if (IS_ERR(base))
return PTR_ERR(base);
@@ -632,15 +993,18 @@ static int spi_geni_probe(struct platform_device *pdev)
spi->num_chipselect = 4;
spi->max_speed_hz = 50000000;
spi->prepare_message = spi_geni_prepare_message;
+ spi->unprepare_message = spi_geni_unprepare_message;
spi->transfer_one = spi_geni_transfer_one;
spi->auto_runtime_pm = true;
spi->handle_err = handle_fifo_timeout;
- spi->set_cs = spi_geni_set_cs;
spi->use_gpio_descriptors = true;
init_completion(&mas->cs_done);
init_completion(&mas->cancel_done);
init_completion(&mas->abort_done);
+ init_completion(&mas->xfer_done);
+ init_completion(&mas->tx_cb);
+ init_completion(&mas->rx_cb);
spin_lock_init(&mas->lock);
pm_runtime_use_autosuspend(&pdev->dev);
pm_runtime_set_autosuspend_delay(&pdev->dev, 250);
@@ -661,6 +1025,15 @@ static int spi_geni_probe(struct platform_device *pdev)
if (ret)
goto spi_geni_probe_runtime_disable;
+ /*
+ * query the mode supported and set_cs for fifo mode only
+ * for dma (gsi) mode, the gsi will set cs based on params passed in
+ * TRE
+ */
+ mas->cur_xfer_mode = get_xfer_mode(spi);
+ if (mas->cur_xfer_mode == GENI_SE_FIFO)
+ spi->set_cs = spi_geni_set_cs;
+
ret = request_irq(mas->irq, geni_spi_isr, 0, dev_name(dev), spi);
if (ret)
goto spi_geni_probe_runtime_disable;



--
With best wishes
Dmitry