Re: [PATCHv3 1/6] firmware: stratix10-svc: add COMMAND_AUTHENTICATE_BITSTREAM flag

[Tom Rix]

On 1/25/21 12:56 PM, richard.gong@xxxxxxxxxxxxxxx wrote:
> From: Richard Gong <richard.gong@xxxxxxxxx>
>
> Add COMMAND_AUTHENTICATE_BITSTREAM command flag for new added bitstream
> authentication feature. Authenticating a bitstream is to make sure a signed
> bitstream has the valid signatures.
>
> Except for the actual configuration of the device, the bitstream
> authentication works the same way as FPGA configuration does. If the
> authentication passes, the signed bitstream will be programmed into QSPI
> flash memory and will be expected to boot without issues.
>
> Clean up COMMAND_RECONFIG_FLAG_PARTIAL flag by resetting it to 0, which
> aligns with the firmware settings.
>
> Signed-off-by: Richard Gong <richard.gong@xxxxxxxxx>
> ---
> v3: no change
> v2: new added
> ---
>  include/linux/firmware/intel/stratix10-svc-client.h | 11 ++++++++---
>  1 file changed, 8 insertions(+), 3 deletions(-)
>
> diff --git a/include/linux/firmware/intel/stratix10-svc-client.h b/include/linux/firmware/intel/stratix10-svc-client.h
> index ebc2956..7ada1f2 100644
> --- a/include/linux/firmware/intel/stratix10-svc-client.h
> +++ b/include/linux/firmware/intel/stratix10-svc-client.h
> @@ -51,12 +51,17 @@
>  #define SVC_STATUS_NO_SUPPORT		6
>  
>  /*

This patch fails to apply, i believe the conflict is because in mainline this is '/**' not '/*'

Please check or point me at the branch/tag you are using.

I am using char-misc-next.

Tom

Tom